Installation manual

 Page 22 
If you will install the unit on the ground or
on a concrete mounting platform , do the
following:
1. Mark the positions for four expansion bolts
based on dimensions in the Unit Mounting
Dimensions chart.
2. Pre-drill holes for expansion bolts.
3. Clean concrete dust away from holes.
4. Place a nut on the end of each expansion bolt.
5. Hammer expansion bolts into the pre-drilled
holes.
6. Remove the nuts from expansion bolts, and
place outdoor unit on bolts.
7. Put washer on each expansion bolt, then
replace the nuts.
8. Using a wrench, tighten each nut until snug.
WARNING
Step 3: Anchor outdoor unit
The outdoor unit can be anchored
to the ground or to a wall-mounted
bracket.
UNIT MOUNTING DIMENSIONS
The following is a list of different
outdoor unit sizes and the distance
between their mounting feet.
Prepare the installation base of the
unit according to the dimensions
below.
A
W
B
D
Air inlet
Air outlet
Air inlet
A
W
B
D
Air inlet
Air outlet
Air inlet
Fig. 4.5
Outdoor Unit
Installation
WHEN DRILLING INTO CONCRETE, EYE
PROTECTION IS RECOMMENDED AT ALL
TIMES.
Outdoor Unit Dimensions
W x H x D
Mounting Dimensions
Distance A Distance B (mm/in)
26.8”x17”x11.2” (681x434x285mm) 18.10” (
460mm)
11.49” (
292mm)
27.5”x21.6”x10.62” (700x550x270mm) 17.7” (450mm) 10.24” (
260mm)
30.7”x21.25”x9.85” (780x540x250mm) 21.6” (549mm) 10.85” (
276mm)
33.25”x27.5”x12.6” (845x700x320mm) 22” (560mm) 3.2” (335mm1)
31.9”x22”x12.2” (810x558x310mm) 21.6” (549mm) 12.8” (325mm)
35.4”x33.85”x12.4” (900x860x315mm) 23.2” (590mm)
13.1” (333mm)
37.2”x31.9”x15.55” (945x810x395mm) 25.2” (640mm)
15.95” (
405mm)
37.21”x31.9”x16.53” (
946x810x420mm)
26.5” (
673mm)
15.87”
(
403mm)
37.21”x31.9”x16.14” (
946x810x410mm)
26.5” (
673mm)
15.87”
(
403mm)
33.25”x27.63”x14.29” (
845x702x363mm)
21.26”
(
540mm)
13.8” (
350mm)
27.5”x21.6”x10.82” (700x550x275mm) 17.7” (450mm) 10.24” (
260mm)
30.3”x21.85”x11.81” (770x555x300mm) 19.2” (487mm) 11.73” (
298mm)
31.5”x21.8”x13.1” (800x554x333mm) 20.24” (
514mm)
13.39” (
340mm)