PACKAG E D T E R M IN AL A IR C O N D ITI O N ER Before using your air condition er, plea se read this m anual carefully and kee p it for future reference.
CONTENTS 1. SAFETY PRECAUTIONS..................................................................2 2. IMPORTANT SAFETY INSTRUCTIONS ..........................................4 3. AIR CONDITIONER FEATURES.......................................................5 4. CONTROL PANEL OPERATION.......................................................6 5. INSTALLATION .................................................................................7 6. CARE AND CLEANING...................................................
SAFETY PRECAUTIONS To prevent injury to the user or other people and property damage, the following instructions must be followed. Incorrect operation due to ignoring of instructions may cause harm or damage. The seriousness is classified by the following indications. ! WARNING This symbol indicates the possibility of death or serious injury. ! CAU TION This symbol indicates the possibility of injury or damage to property. Meanings of symbols used in this manual are as shown below. Never do this.
! CAUTION When the air filter is to be removed, do not touch the metal parts of the unit. It may cause an injury. Do not clean the air conditioner with water. Water may enter the unit and degrade the insulation. It may cause an electric shock. When the unit is to be cleaned, switch off, and turn off the circuit breaker. Do not put a pet or house plant where it will be exposed to direct air flow. Do not clean unit when power is on as it may cause fire and electric shock, it may cause an injury.
IMPORTANT SAFETY INSTRUCTIONS WARNING NOTE The power supply cord with this air conditioner contains a current detection device designed to reduce the risk of fire. Please refer to the section Operation of Current Device for details. In the event that the power supply cord is damaged, it cannot be repaired-it must be replaced with a cord from the Product Manufacturer. Do not, und er a ny circums tances, cut, rem ove, or bypass the groundi ng prong.
AIR CONDITIONER FEATURES This unit has many featrues.The servicer must be familiar with these features in order to properly service the unit. Compressor Restart Delay This feature extends the overall life of compressor by preventing the short-cycling of the air conditioner.When the compressor restarts,the unit is designed to give a minimum of three minutes to have a time of equalizing the refrigerant pressures for optimizing cycling.
CONTROL PANEL OPERATION The control pane l keypad will look like the following Fig.1: HIGH MED LOW FAN COOL HEAT POWER Fig.1 POWER - Press the POW ER button to turn the unit on or off. W hen the unit is on,the power indicator light will be green.When the unit is off,the light will go out. MODE - Push this button to cycle through the modes from COOL-HEAT-FAN-COOL.The indicator light beside the "M ODE" option will illuminate, identifying the mode selected.
INSTALLATION Dim ension of air cond itioner HOW TO INSTALL THE UNIT ! CAUTION 1067mm/ 42i nch There are sharp edges that can cause serious cuts. When lifting the air conditioner,it is HEAVY.Use 2 peo ple to lift. 408mm/16inc h - For existing sleeve,you shou ld measure the wall sleeve dimensions. 606mm/23.9inc h - Install the new air cond itioner according to these installation instructions to achieve the best performan ce.
INSTALLATION(CONTINUED ) UNIT INSTALLATION (CONTINUED) - Rotate the vent control lever to either open or close the vent door.(See Fig.6) Vent control lever Vent closed Vent open Fig.6 NOTE:When vent control lever set at CLOSE,only the air inside the room is circulated and filtered. When set at OPE N,some outdoor air will be drawn into room.This will reduce heat ing or cooling efficiency.
CARE AND CLEANING FRONT PANEL AND CASE - Turn unit off and disconnect power supply.To clean, use water and a mild detergent.DO NOT use bleach and abrasivers.Som e commercial cleane rs may damag e the plastic parts. OUTDOOR COIL - Coil on outdo or side of unit shou ld be checked regularly.Unit will ne ed to be remo ved to inspect dirt bu ild-up that will occur on the inside of the coil. If clogge d with dirt and soo t ,coil should be professionally cleaned.
TROUBLESHOOTING POSSIBLE CAUSES UNIT DOES NOT START Unit ma y have become unp lugged Fuse may have blown Circuit breaker may have bee n tripped Unit ma y be off Unit ma y be in a protection mode. UNIT NOT COOLING/HEATING ROOM Unit air discharge section is blocked Tem perature setting is not high or low enough Note:Setpoint limits may not allow the unit to heat or cool the room to the temperature desired.Check section on dipswitch settings. Unit air filters are dirty.
The Klimaire logo is a registered Trademark of Klimaire Products inc. Copyright 2010 Klimaire Products inc. 2190 NW 89 Place, Doral, FL 33172 - USA Tel: (305)594-4972 Fax (305) 675-2212 www.klimaire.com sales@klimaire.com The design and specifications are subject to change without prior notice for product improvement. Consult with the sales agency or manufacturer for details.