Tech Support: 1-800-KLIPSCH State-of-the-Art Wireless Portable AudioRock Installs in 5 minutes or less! OWNER’S MANUAL and installation instructions Note: The AudioRock is an add on unit to an existing LightSpeaker® System. You need a LightSpeaker® Transmitter to supply audio and control the music on this unit. The Transmitter and Remote discussed in the manual are sold separately. AudioRock Manual v2.
Tech Support: 1-800-KLIPSCH The AudioRock speaker uses a 12 volt Lithium Ion Battery for operation. Please review the following safety instructions before use: Li Ion Battery Safety Instructions: Misuse can result in the batteries short-circuiting, the insulator melting and damage to the safety valves or safety mechanisms, leading to leakage, heat generation, or rupturing. Please observe the following precautions when using batteries.
Tech Support: 1-800-KLIPSCH IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions. Keep these instructions. Heed all Warnings. Follow all instructions. 2. Do not use this apparatus in water. The apparatus can be exposed to rain, snow or any weather element without risk of injury or damage. Do not submerge in water or other liquids. The product is water resistant not water proof. 3. Clean only with a wet rag or light spray of water from garden hose.
Tech Support: 1-800-KLIPSCH Congratulations Thank you for choosing the wireless, portable AudioRockTM from Klipsch® Speakers. With proper installation and operation, you will enjoy years of trouble-free use. Klipsch Speakers offers numerous loudspeakers for use inside or outside your home. To see the complete Klipsch Speakers product assortment, visit us on the Internet at: www. Klipsch.com. 4 AudioRock Manual v2.
Tech Support: 1-800-KLIPSCH Table of Contents AudioRock Overview.............................................................................6 What is in this box................................................................................8 Installation Considerations................................................................9 Selecting Locations...............................................................................9 Setting up Zones..........................................................
Tech Support: 1-800-KLIPSCH AudioRockTM Overview This wireless portable AudioRock is intended to install in a few minutes and since it runs on batteries it increases the flexibility of where these speakers can be used. The system can use up to 8 wireless AudioRocks (when used with a Klipsch Speakers LightSpeaker® transmitter) to provide audio to your entire outdoor area.
Tech Support: 1-800-KLIPSCH find a standard Edison socket. They can provide “green” lighting and outstanding sound throughout your home. The LightSpeakers are available from your retailer or at www.Klipsch.com. The entire system provides even greater flexibility to you as the owner; because you can take it with you if you move. If you do need to remove it, it leaves no trace that the system was ever installed or used. What’s in the box 7 AudioRock Manual v2.
Tech Support: 1-800-KLIPSCH What’s in this Box Wireless AudioRock Owner’s Manual One Charger One Rechargeable Lithium-ion Battery NOTE: The AudioRock can only be used with the Klipsch Speakers wireless LightSpeaker transmitter. It cannot be used or operated without the LightSpeaker transmitter. Remote and transmitter sold separately. 8 AudioRock Manual v2.
Tech Support: 1-800-KLIPSCH Installation Considerations Remember the outdoor line-of-sight range of the system is up to 125 feet, so as long as the distance from the transmitter to the farthest AudioRock, in any direction, is less than 125 feet, the placement of the transmitter is up to you. Selecting AudioRockTM Locations Your wireless AudioRock can be placed anywhere it is convenient in your outdoor listening areas.
Tech Support: 1-800-KLIPSCH Setting Up Zones If you have more than one AudioRock and you want to set up separate listening zones in your outdoor area, you have the option of setting up a second zone. An audio zone is any area or group of areas where you want the same audio source playing and want the volume of the speakers to be about the same. If you want an area to have different volume level or play a different set of music then use the two zone option.
Tech Support: 1-800-KLIPSCH Preparing AudioRockTM for Installation Please charge your battery for your rock by plugging in the power supply and inserting the battery into the charger. Allow at least 8 hours for the first charge. NOTE: Leaving the battery in the charger for periods longer than 24 hours may reduce battery life. When an uncharged battery is placed in the charger the LED on the front of the charger will shine RED; when charging is complete the LED will turn green.
Tech Support: 1-800-KLIPSCH Installation Instruction Step 1: After the battery has been charged, install it into the battery compartment. Be sure it is pushed all the way in. 1 Zone Volume Pairing 2 Step 2: Be sure the zone switch on the back of your AudioRock is set to zone 1 unless you are setting up a two z one system. If you intend to set up a two zone system be certain the zone switch is set the number corresponding to the zone you intend to place it. 12 AudioRock Manual v2.
Tech Support: 1-800-KLIPSCH Pairing the AudioRockTM to the Transmitter Before you can begin using and enjoying your new portable wireless AudioRock system it is necessary to “teach” your AudioRock the identity of the transmitter you are using; this teaching is called “pairing” and is very easy to do. Step 1: With the Transmitter power on (LED on front will be lit), find and press the pairing button on the back of the unit. You may need a sharp object like a pen to press the button in.
Tech Support: 1-800-KLIPSCH When the pairing light turns solid green, the pairing is complete. You have about of 30 seconds to get this done. If this is not enough time to pair all of your AudioRock, simply repeat for each AudioRock in your system. Step 3: When all units are paired, you are ready to start using and controlling the system.
Tech Support: 1-800-KLIPSCH Operating and Controlling Your AudioRockTM AudioRock Electronics Battery compartment accepts supplied rechargeable battery providing up to 8 hours of playback. Playback time will depend upon how loud you listen to your music; the lower the average level the longer the battery will last. Built-in wireless receiver allows reception and control of the loudspeaker up to 125 feet away from your LightSpeaker transmitter and remote control.
Tech Support: 1-800-KLIPSCH AudioRock Specifications: This stereo outdoor wireless rock speaker with 5¼” woofer is optimally tuned for outdoor performance. The sound is electronically equalized to provide superior acoustic performance in open-air environments. Neutral Granite styling allows this system to blend unobtrusively into most outdoor environments. This single-speaker stereo unit provides dual-channel audio from a single enclosure.
Tech Support: 1-800-KLIPSCH Warranty - Home and Commercial Audio (U.S.) The Warranty below is valid only for sales to consumers in the United States. KLIPSCH, LLC (“KLIPSCH”) warrants this product to be free from defects in materials and workmanship (subject to the terms set forth below) for a period of one (1) year from the date of purchase. During the Warranty period, KLIPSCH will repair or replace (at KLIPSCH’s option) this product or any defective parts (excluding electronics and amplifiers).
Tech Support: 1-800-KLIPSCH REPAIRS OR REPLACEMENTS AS PROVIDED UNDER THIS WARRANTY ARE THE EXCLUSIVE REMEDY OF THE CONSUMER. KLIPSCH SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF ANY EXPRESS OR IMPLIED WARRANTY ON THIS PRODUCT. EXCEPT TO THE EXTENT PROHIBITED BY LAW, THIS WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER EXPRESS AND IMPLIED WARRANTIES WHATSOEVER, INCLUDING BUT NOT LIMITED TO, THE WARRANTY OF MERCHANTABILITY AND FITNESS FOR A PRACTICAL PURPOSE.
Tech Support: 1-800-KLIPSCH THIS DEVICE COMPLIES WITH FCC RULES PART 15. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) This device must accept any interference received including that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Tech Support: 1-800-KLIPSCH Klipsch Worldwide Corporate Headquarters 3502 Woodview Trace, Suite 200 Indianapolis, IN 46268 For more detailed installation instructions go to www.klipsch.com Klipsch Technical Support Toll Free: 1-800-KLIPSCH (1-800-554-7724) Monday - Friday, 8:00 AM - 5:30 PM EST E-mail: technicalsupport@klipsch.
