COMM SAT SPEAKER SYSTEM OWNER'S MANUAL
C O M M S AT S P E A K E R S Y S T E M IMPORTANT SAFETY INSTRUCTIONS READ these instructions. KEEP these instructions. HEED all warnings. FOLLOW all instructions. DO NOT use this apparatus near water. CLEAN ONLY with dry cloth. DO NOT block any ventilation openings. Install in accordance with the manufacturer's instructions. 8. DO NOT install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9.
2. Install the Comm Sat Speakers and Mounts. First, attach the Speaker to the Mount post (included with the Mount). Simply thread the post into the speaker until hand tight. Now pull the wire pigtail attached to the Comm Sat through the hole in the Mount tube and plate and make your connections in the box behind the plate. Once you have done this, attach the plate to the box. With the adjustment point on the Mount loose, adjust Speaker direction as desired.
C O M M S AT N E T W O R K S P E C I F I C AT I O N S COMM SAT NETWORK BANDWIDTH 1 TRANSFORMER TAPS CROSSOVER INPUT CONNECTORS ENCLOSURE MATERIAL HEIGHT WIDTH DEPTH WEIGHT SHIPPING WEIGHT FINISH n/a 70V: 30W, 100V: 60W 100Hz 12dB/Octave highpass Barrier strip Steel 4.375" (11.1cm) 6.125" (15.6cm) 6.125" (15.6cm) 5 lbs. (2.3kg) 6 lbs. (2.
C O M M S AT S P E A K E R S P E C I F I C AT I O N S COMM SAT SPEAKER BANDWIDTH 1 POWER HANDLING2 MAX CONT. SPL 3 SENSITIVITY 4 NOMINAL IMPEDANCE HIGH FREQUENCY CROSSOVER DRIVE COMPONENTS 120Hz-20kHZ ± 4dB (-10dB @ 42Hz) 70W (15.5V @ 3.2 ohm input) 107dB 90dB @ 2.83 volts/1 meter 8 ohms (3.2 ohm minimum @ 5.5Hz) 4900Hz Two-way system using one .75" (1.9cm) magnetically shielded, cloth dome compression driver tweeter with a 90˚ x 40˚ Tractrix® Horn and one 3.5" (8.
S U B W O O F E R S P E C I F I C AT I O N S CA-800-TSW FREQUENCY RESPONSE 1 51-135kHz ± 4dB -10dB 42Hz POWER HANDLING 2 MAX CONTINUOUS OUTPUT 3 SENSITIVITY (2.83V/1M) 4 NOMINAL IMPEDANCE CROSSOVER TRANSDUCERS ENCLOSURE TUNING ENCLOSURE MATERIAL INPUT CONNECTORS TRANSFORMER TAPS 150W (25V) 111dB 92dB 6 ohms (4 ohm min @92Hz) 12dB/Octave low-pass, 150Hz One 8” woofer with IMG cone Vented System via front firing ports All-weather ABS plastic, paintable 4 point terminal strip 70V: 60W, 30W, 15W, 7.5W, 3.
T Y P I C A L I N S TA L L AT I O N - D I A G R A M 1
3502 Woodview Trace, Suite 200 Indianapolis, Indiana 46268 USA 1. 800 . KLIPSCH • klipsch.
