Operation Manual

This warranty is invalid if the factory applied serial number or date
stamp has been altered or removed from this product.
REPAIRS OR REPLACEMENTS AS PROVIDED UNDER THIS
WARRANTY ARE THE EXCLUSIVE REMEDY OF THE CONSUMER.
KLIPSCH SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR
CONSEQUENTIAL DAMAGES FOR BREACH OF ANY EXPRESS OR
IMPLIED
WARRANTY ON THIS PRODUCT. EXCEPT TO THE EXTENT
PROHIBITED BY LAW, THIS WARRANTY IS EXCLUSIVE AND IN LIEU
OF ALL OTHER EXPRESS AND IMPLIED WARRANTIES WHATSOEV-
ER, INCLUDING BUT NOT LIMITED TO, THE WARRANTY OF
MERCHANTABILITY AND FITNESS FOR A PRACTICAL PURPOSE.
Some states do not allow the exclusion or limitation of incidental
or consequential damages or implied warranties so the above
exclusions may not apply to every customer. This warranty gives
you specific legal rights, and you may have other rights which vary
from State to State.
To obtain warranty service, please follow these directions:
1. If you purchased this product from a retail store, please return
this product to such store in its original packaging along with
proof of purchase.
2. If you purchased this product from a computer manufacturer,
please contact that manufacturer.
3. For purchases made through www.klipsch.com, please call
KLIPSCH Customer Service at 1-888-554-5665. Product may
only be returned to KLIPSCH after a Return Authorization
number has been obtained from KLIPSCH.
Returned product must be shipped, freight prepaid to KLIPSCH in
either its original packaging or packaging affording an equal
degree of protection along with proof of purchase.
WARRANTY OUTSIDE THE UNITED STATES AND CANADA
The Warranty on this product if it is sold to a consumer outside of the
United States or Canada shall comply with applicable law and shall be
the sole responsibility of the distributor that supplied this product. To
obtain any applicable warranty service, please contact the dealer from
which you purchased this product, or the distributor that supplied this
product.
FCC AND CANADA COMPLIANCE INFORMATION:
Note: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions,
may cause harmful interference to radio communica-
tions.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
Modifications not expressly approved by the manufacturer could
void the user's authority to operate the equipment
under FCC rules.
This class B digital apparatus complies with Canadian ICES-003.
Cet appareil numerique de la classe B est conforme a la norme
NMB-003 du Canada.
iFi Transmitter Information
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received, including
interference that may cause undesired operation.
L'utilisation de ce dispositif est autorisee seulement aux conditions
suivantes :
1. il ne doit pas produire de brouillage et
2. l'utilisateur du dispositif doit etre pret a accepter tout
brouillage radioelectrique recu, meme si ce brouillage
est susceptible de compromettre le fonctionnement du
dispositif.
iFi Receiver Information:
FCC Declaration of Conformity
Trade Name: Klipsch Audio Technologies
Product Name: Klipsch iFi Audio System
Model Number: iFi
These devices were tested and found to comply with Part 15 of the
FCC Rules. Operation is subject to the following conditions: The
devices may not cause harmful interference, and the devices must
accept any interference received, including interference that may
cause undesired operation.
Responsible Party
Manufacturer: Klipsch Audio Technologies
Address: 3502 Woodview Trace, Suite 200
Indianapolis, IN 46268
Telephone: [phone]
Date: 3/3/05
Signature:
Printed Name: Clinton Bradley