Palladium® P-312W Owner’s Manual
Important Safety Instructions 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. Page 2 READ these instructions. KEEP these instructions. HEED all warnings. FOLLOW all instructions. DO NOT use this apparatus near water. CLEAN ONLY with dry cloth. DO NOT block any ventilation openings. Install in accordance with the manufacturer’s instructions. DO NOT install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
Preparing the Loudspeaker Positioning Subwoofers Connection Procedure: Never allow objects or furniture to impede the subwoofer or place objects on top of it! There is a specific procedure to be followed: • • • • • Switch off and unplug the amplifier/s and all source electronics from the mains power. Place the subwoofer in the general area where you want it. Connect the subwoofer following the instructions under the “connecting the subwoofer” section of this manual.
Connecting the Subwoofer Features and Controls Caution: Turn off your preamplifier/receiver and your subwoofer before making any connections! Touch Panel Controls Inputs and Outputs Line In Your Palladium Series powered subwoofer is connected via line-level connections only. RCA-type and XLR inputs are provided and either may be used. Do not connect both at the same time.
Features and Controls - 2 Features and Controls - 3 EQ Mode Room Correction This screen is used to select two different bass emphasis settings titled “Punch” and “Depth”. They are designed to complement different types of program material, such as movie soundtracks or music. The “Punch” setting emphasizes the 55Hz region, while the “Depth” setting boosts the 30Hz range. A third setting is titled “Flat”, which defeats these two settings. Use the Left/Right touch keys to select the desired EQ setting.
Features and Controls - 4 Back Panel Features Keypad Lock This section describes the features and connections found on the amplifier on the back panel of the subwoofer. It also describes the manner for connecting a second subwoofer as a “slave” unit to the primary subwoofer. This screen is used to lock the keypad and prevent unintentional changes to your settings by other users. After making all desired adjustments, press the Enter key to lock the keypad.
Remote Control Operation About Your Loudspeaker This section describes the features found on the supplied remote control for your Palladium P-312W subwoofer. The remote control works via infrared and, as such, will need a clear line of sight to the infrared receiver located on the lower right quadrant of the front panel. The remote will work with or without the front-panel grille installed.
Conclusion Care and Maintenance FCC AND CANADA EMC COMPLIANCE INFORMATION Very little maintenance is required. To maintain the finish of the loudspeakers, wipe them carefully with a soft lint-free polishing cloth. Occasionally, and to remove fingermarks etc., wipe the cabinets with a barely damp clean soft cloth and finish with a lint-free polishing cloth. NEVER use any form of spray, furniture polish, saturated polishing cloth, or the like. Doing so will dull and streak the fine finish of the cabinets.
3502 Woodview Trace, Suite 200 Indianapolis, Indiana 46268 USA 1.800.KLIPSCH • www.klipsch.com www.klipsch.
