DR0520L

SAFETY INSTRUCTIONS
1. Please preserve this manual and the packing carefully for later reference. If you give this
product to a third party remember to hand over this manual as well.
2. This product is NOT meant for commercial use, but is ONLY intended for domestic use.
To be used only under the supervision of adults. Never leave your child unsupervised on
the swing, in order to avoid the risk of falling down.
3. Follow the assembly and maintenance instructions, in order to prevent your child from
falling, tumbling down and to prevent the tearing of ropes.
4. We recommend that you set up the swing on an even surface and maintain a distance of
at least 2m from other structures or obstacles, e.g. fence, garage, house, projecting
branches, clotheslines or electric cables.
6. Not suitable for children below 3 years of age. Risk of strangulation!
7. Children below 3 years of age are still unable to maintain their balance.
8. Since children have different development patterns, please check beforehand if your
child is able to maintain his balance.
9. The recommend height from the ground to swing seat is 20in (50cm).
MAINTENANCE
1. Always pay attention to the following points if the swing was not in use for a longer
period (Especially at the beginning of a new season!).
2. Lubricate all metal parts. Check all the caps on screws and sharp edges and replace them,
if required. Check the swing seats, chains, ropes and other accessories for any signs of
wear.
3. Check the ropes and rings constantly for decay, wear and tear resistance. The best way to
check this is to turn the ropes till their inside becomes visible! Check the knots regularly
for tightness. Examine the wood regularly for decay and cracks.
4. Also check if wood shavings are sticking out from the swing board.
These should be abraded in order to avoid injuries. Do not expose the swing to the
weather during longer periods of rain and in autumn / winter.
5. Always replace defective parts with original spares.
PART LIST
Swing seat
1pcs
Spanner
suspension ropes
and bolts
T
2pcs
Nut
tree strap
7T
2pcs
Spacer
o
Carabiner
2pcs
EVA foam
padded tube
8
Nut cap
4pcs
SWING ASSEMBLY INSTRUCTION
Attention: This is the general user manual of swing, the actual color refers to the item you
purchased.
1. Insert 4 Tubes into the swing seat.
2. Connect two joints at the left side of swing, make sure two holes align.
3. Align the pipe ends at the right side of swing, then push down the short tube gently until
it is even.
4. Insert the bolt into the hole at the front side of swing.
5. Put the washer and nut onto the bolt, and tighten with a wrench until 3-4 threads of bolts
are exposed, then put the nut cap onto the bolt and tighten it. Please make sure all the
screws are tightened for your safety. (You need a wrench to fasten nut and nut cap.)
6. Assembly complete.