Assembly Instruction Swing Set Assembly requires at least two adults. Read the instruction manual carefully before assembling or using the swing set. Make sure all parts are complete, and identify and separate all parts first. Keep this manual for future reference.
SAFETY INSTRUCTION The safety of your children is our primary concern! The swing set is ONLY for domestic use, not for public use. Do not use this swing set on hard-packed soil, concrete, or any kind of hard surface. The swing set should be set on a flat surface and maintain a distance of at least 2 meters from other structures or obstacles, such as fences, garages, houses, projecting branches, clotheslines or electric cables, etc.
2
3
ASSEMBLY AND INSTALLATION INSTRUCTIONS AREA OF INSTALLATION- SWING SET TOP BAR STEP 1–Assemble the top bar frame of the swing set Connect Top Bars 1 and 2 together with 13, 15, 18, 14, 20, 22 and 21 as shown below. All round holes should be facing up and concave holes facing down. NOTE: For easier assembly, do not tighten the bolts all the way initially to allow room for adjustment. You must go back and fully tighten all bolts after the entire swing set is assembled.
AREA OF INSTALLATION –SIDE LEGS STEP2–Assemble the support legs of swing set Connect 3 to 1 and 2 secure with 13, 15, 18 and 14 as shown below. Note: Please make sure that concave holes face down and round holes face up.
AREA OF INSTALLATION - SIDE LEG & CROSS BARS STEP 3–SIDE LEG & Cross Bars Assembly Attach 3 and 5 to the outer sides of 4 and secure using 13, 15, 18,16 and 14 as shown below. REMINDER: Once you have completed assembling the swing frame, make sure to go over the previous steps and fully tighten all the nuts and bolts.
AREA OF INSTALLATION– FLYING SAUCER Step4–Flying Saucer Assembly Slide Flying Saucer Tubes 7 into the pockets of Flying Saucer 10 as shown in DIAGRAM A. Connect the four tubes together and align the holes with the round holes facing downward. Connect Short Eye Bolt with String 9 to the Flying Saucer, secure with 11 and 12 as shown in DIAGRAM B.
Step5–Flying Saucer Assembly (continued) Insert U Bolt for String 9 into the holes on 1, 2 secure with 15,14 and 18 as shown below.
STEP 6 - Flying Saucer Assembly (continued) Flying Saucer Installation Method 2 10
STEP 7 - Ground Stakes Assembly Place the ground stakes near the swing set's lower legs, screw them into the ground, then secure the stakes to the legs using 26, 25,24, 18,24 and 14 as shown below.
Congratulations! You have now completed installing the equipment. Please make sure to go back and check all hardware and ensure all bolts and nuts are securely tightened before using the playground equipment. Warning! Do not let children use the playground equipment until it is properly assembled and anchored. Constant adult supervision is required during use. Please make sure all supervisors have read and understand the warnings and use instructions contained in this manual.