Assembly Instructions

Read the instruction manual carefully before assembling or using the swing. Keep this manual for future reference.
The swing seat is ONLY for domestic use, not for public use.
Children MUST NOT use this swing seat until the installation is complete.
Children must be under supervision when they contact or use the product to prevent the risk of falling or the
strangulation of long ropes.
Periodically check and maintain the swing seat, and ensure that all hardware is in good condition.
The recommend height from the ground to the swing seat is 20in (50cm)
Remember to check the following points before using the swing again when it is not in use for a longer period
(Especially at the beginning of a new season):
Lubricate all metal parts. Double check bolt coverings, sharp edges, and corners.
Check all moving parts including swing seat, ropes and chains for wear, rust, or other deterioration.
Do not leave the swing exposed to the weather during long periods of rain and sun.
- 01 -
The safety of your children is our primary concern!
Assembly Instructions
Swing Seat
Not suitable for children under 3 years old.
CARE AND MAINTENANCE
Always replace defective parts with original spares.
SAFETY INSTRUCTION
PARTS LIST
QUANTITY
ITEM NAME
IMAGE
QUANTITY
ITEM NAME
IMAGE
SWING SEAT
1PC
- 02 -
SUSPENSION
ROPES+NUT+
WASHER
CARABINER
NUT CAP
SPANNER
TREE STRAP
SWIVEL
2PCS
2PCS
4PCS
1PC
2PCS
1PC
ASSEMBLY INSTRUCTION
Step 1: Place the swing seat on the ground, and keep four tubes flat.
Step 2: Joint two adjacent tubes together, and we will get two semi-circles.
Step 3: Hold the two semi-circles and align the tube orifices to each other.
Step 4&5: Push and press down the tubes until connected.
Step 6: Align the two holes, then insert the bolt into the holes.
Step 7: Put the washer and nut cap onto the bolt and tighten it. Make sure all the screws are tightened for your safety.
(For a tight screw, use an open-end wrench.)
Step 8: Assembly finished.
Step1 Step2 Step3 Step4
Step5 Step6 Step7 Step8