Lr Ea Lye Cl ® This product is not intended for public use. ONLY intended for domestic use. @ Not suitable for children below 5 years of age. ® Do not exceed maximum weight 250 LBS. ® Since children have different development patters, we suggest that adult supervision be required. ® Inspect the strap before each use. Do not use when there is any abrasions, cuts, tears, bums, sew patter damaged or alterations. If the strap is showing signs of wear, do not use, replace as necessary.
Trees Distance before Install ® 50ft lifeline trees distance 89-421 max.distance 42ft tree diameter 7-12In HEN max.distance 37ft tree diameter 15-19in min.distance 20ft tree diameter 7-25in Assembly Instructions 1. Attach the strap fo triangle clip, then move the triangle clip to the other end of the strap where there Is a black mark. Tips. The distance of triangle clips can be adjusted depends on different environments and users. Tips.
2. Use the same method to install the other 14 triangle clips. It is recommended that the distance between each triangle clip is 16in. Note: you can measure the distance by the monkey bar 3. Wrap the cushion around the tree, fasten it.then set the Ninja line height to around 12" above the users highest reach. ong side other side 4. Thread the end of the ninja line( 2In*50ft ) through the slotted spool from bottom and straighten the line. 5. Pull the ratchet handle up and down until the line is tight.
6. Ratchet teeth can damage the line. Keep the line and ratchet straight while cranking and do not over fill the ratchet with the line. 7. Hook the obstacles into the clip hole via carbine, and secure the threaded lock nuts. (Note: the monkey bars dean to put the two connectors into one carbine, as shown in the figure. Iris recommended to install the rope ladder on the left or right, as shown in the picture.
9. Wrap the cushion around the tare, fasten it then set the Slack line (narrower). You can set and adjust the height of the nether slacker line according to your kids height. (Tips: Smaller Ratchet for 1.5 in*50ft Slack line) 1. Unlock the ratchet by pulling out the release lever firmly. 2. While holding the release lever in horizontal line, pull the ratchet all the way open until it is released, then pull the line out from the straightened end .
