User's Manual

Klover MiK 26 Assembly Sequence

US Patent #9014402

Klover Products Inc.

5807 W Fenrick Rd, Janesville, WI 53548

(888) 299-9009 - support @KloverProducts.com

Step 1 - Install left and right handles with the connectors toward the center of the dish (plates outward)

Step 2 - Install rear cross bar (Rotate rear bar 180 degrees if the connectors won’t snap into place)

(You can use the optional monopod mount instead of standard cross bar for this step.)

Step 3 - Focus microphone - Option #1 - Use label to position mic 2 ¼” behind mic yoke

(Steps 4, thru 7 are on back of sheet)

PAGE 1
Klover MiK 26 Assembly Sequence Step 1 - Install left and right handles with the connectors toward the center of the dish (plates outward) Step 2 - Install rear cross bar (Rotate rear bar 180 degrees if the connectors won’t snap into place) (You can use the optional monopod mount instead of standard cross bar for this step.) Step 3 - Focus microphone - Option #1 - Use label to position mic 2 ¼” behind mic yoke (Steps 4, thru 7 are on back of sheet) US Patent #9014402 Klover Products Inc.
PAGE 2
Step 4 - Install Mic Yoke Thumb screw should be on bottom, small targeting screws on top, and arrows in both end plates pointing up. Remove second end plate from yoke, slide first end plate onto locator pins, then place second end plate onto locator pins on opposite side of dish and snap into place. (If the end plates have been removed you may have switch the two end plates in order to properly align them. There are small flats on the connectors that should match.