Product Manual

Page 7 of 14
Assembly Instructions
Refer to the following illustration and the Parts Diagram during assembly.
1. Place the base panel on a sturdy surface with the side lips facing up. Find the long slots at the
back of the base unit. Insert the Axle Clips into the slots from the top, then slide the axle through
the large hole in the clip. Repeat for both clips.
2. Slide a wheel on each side.
3. Secure each wheel with a flat washer and cotter pin.
4. Find the left side panel of the cabinet. Align the pre-drilled holes in the lip of the left side panel
with the pre-drilled holes in the base of the cabinet. The holes in the front of the cabinet base are
where the casters will attach. First secure the left side panel to the base using 4 of the supplied
screws. Then repeat for the right side panel of the cabinet.
5. Take a supplied 10 mm bolt and push it through the pre-drilled holes in the lip of the left side
panel and through the pre-drilled holes in the base of the cabinet and then through the pre-drilled
holes in the flange of the caster. Secure with a 10 mm nut. Repeat for all 4 mounting holes for this
caster. Then repeat for the right side caster.
6. Place the middle shelf on top of the side panels. Secure with supplied screws.
Top Shelf
Middle Shelf
Caster
Wheel
Locking
Cabinet Door
Cable Wraps