Product Manual

Page 16 of 31
a. Lower the table for additional clearance.
b. Place a screwdriver in the lower front notch (1) of the spring cap (2). Hold it in place while
loosening and removing only the outer jam nut (3).
c. e
CAUTION: DO NOT REMOVE THIS INNER NUT, because the spring will forcibly unwind.
d. Carefully turn the spring cap (2) counterclockwise with the screwdriver, engaging the next
notch.
e. Lower the quill to the lowest position by rotating the feed handle in a counterclockwise
direction while holding the spring cap (2) in position.
f. If the quill moves up and down as easily as you desire, tighten the inner nut (4) with the
adjustable wrench. If too loose, repeat steps b through d to tighten. If too tight, reverse steps
c and d. DO NOT OVERTIGHTEN; this will restrict quill movement.
g. Replace the jam nut (3) and tighten against the inner nut (4) to prevent the inner nut from
loosening. Fig. 17