Product Manual

Page 13 of 22
Figure 2.
a. Connect the Pilot Arc cable (Red) on the plasma torch to the Arc Start Cable
Connection. See Figure 3.
b. Connect the Torch Control Cable (Black) 3 prong connector to the Torch Trigger
Control Connection. See Figure 3.
c. Connect the Torch Weld Cable (Yellow Nut) to the Negative (-) output connection.
See Figure 3.
d. Connect the Grounding Cable to the Positive (+) output connection. See Figure 3.
Figure 3.
e. Connect the Ground Clamp to your workpiece.
f. Connect your compressed air source to the gas connection on this units back panel.
Positive (+)
Ground Cable Connection
Negative (-)
Torch Connection
Arc Start
Cable Connection
Torch Trigger
Control Connection