Product Manual

Page 20 of 25
8.5 Move the joint down to be welded by pushing the torch.
8.6 Insert filler metal in the leading edge of the weld puddle as needed.
Maintenance
⚠WARNING
ELECTRIC SHOCK CAN KILL!
 Touching live electrical parts can cause fatal shocks or severe burns. Do not touch live
electrical parts
 Wear dry, hole-free insulating gloves and body protection.
 Disconnect input power before installing, maintaining or servicing this equipment.
Lockout/tagout input power according to OSHA 29 CFR 1910.147.
Maintenance Interval
Maintenance Point
Before Each Use
Inspect all cords and power cables. Replace any cords or
power cables that are damaged or cracked.
Every 3 Months
Inspect all warning and caution labels affixed to this unit. If
they are worn, torn, or otherwise unreadable, then replace the
warning labels.
Inspect, clean, and tighten all weld power connections.
Every 6 months
Unplug the welder and blow out or vacuum the inside.
Troubleshooting
⚠WARNING
ELECTRIC SHOCK CAN KILL!
 Touching live electrical parts can cause fatal shocks or severe burns. Do not touch live
electrical parts
 Wear dry, hole-free insulating gloves and body protection.
 Disconnect input power before installing, maintaining or servicing this equipment.
Lockout/tagout input power according to OSHA 29 CFR 1910.147.
⚠CAUTION
Be aware that the Electrode will be electrically HOT when the Input Power Switch on the welder is
turned on.