User's Manual

User Manual for POD Systems Revision: 0.7
© KMW USA Inc.
1818 E. Orangethrope Ave, Fullerton, CA 92831
Tel. [phone]
www.kmwcomm.com
13
 RF Radiation Exposure
- This equipment complies with RF radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 60 cm with 3dBi antenna
gain or 300 cm with 11dBi antenna gain between the radiator and your body. This transmitter must not
be co-located or operating in conjunction with any other antenna or transmitter. RF exposure will be
addressed at time of installation and the use of higher gain antennas require larger separation distances.
- L’antenne (ou les antennes) doit être installée de façon à maintenir à tout instant une distance minimum
de au moins 60 cm avec le gain d'antenne 3dBi ou 300 cm avec 11dBi gain d'antenne entre la source de
radiation (l’antenne) et toute personne physique. Cet appareil ne doit pas être installé ou utilisé en
conjonction avec une autre antenne ou émetteur.
ELECTRIC SHOCK
The POD System uses the AC or DC power with high voltage level which could result in electric shock and may
cause severe injury.
LASER SAFETY
To avoid eye injury, do not look directly into the optical ports, patch cords or optical cables. Always assume
that optical output is on.
To avoid the potential of radiation exposure, do not leave optic connectors uncovered when not connected.
To check fiber cable connection, use an optical power meter and this should be performed by only technicians
familiar with fiber optic safety practices and procedures.
This equipment uses a Class 1 LASER according to FDA/CDRH Rules. This product conforms to all applicable
standards of 21 CFR Chapter 1, Subchapter J, Part 1040
SAFETY
The POD system should not be modified or used for any other purposes without authority’s permission in
any cases. This could cause fires, electric shock or other injuries.
Be careful not to touch the heat sink part to prevent any degree of burns from high temperature of the heat
sink.
Do not place the DAS equipments close to flammable materials which could reach high temperatures due to
heat dissipation of the DAS equipments.
While working with outdoor DAS equipment with door, make sure to securely fasten the door to prevent any
kinds of damages from slamming shut due to abrupt wind.
UL REGULATION
This equipment complies with UL Standard for safety.