User's Manual

User Manual for POD Systems Revision: 0.7
© KMW USA Inc.
1818 E. Orangethrope Ave, Fullerton, CA 92831
Tel. [phone]
www.kmwcomm.com
48
2.1.10 POD-H-HOM-H
Figure 2-37 POD-H-HOM-H
2.1.10.1 Functions and features
- Converts Downlink RF signal into optical signal and transfers to high power Remote Unit with more than
20W.
- Converts Uplink optic signal received from high power Remote Unit to RF signal and transfers to H-COM, H-
STM, or H-DTM.
- Compensates optic loss between HOM-L and high power Remote unit.
- For 2.6G TDD operation, TDD synchronization signal received from H-FEM-B is transferred to high power
Remote unit via H-HOM-L.
- Communicates with high power Remote unit by PLC modem.
2.1.10.2 Specifications
- Frequency range: VHF, UHF, 600~2700MHz
- Maximum RF Power: -9dBm@DL, 0dBm@UL
- Size, weight, and power consumption : refer to Table 2-1
2.1.10.3 RF port and LED
Figure 2-38 POD-H-HOM-H RF port and LED
 RF Port
- DL 1/DL 2
 Receives downlink signal from H-COM, H-STM or H-DTM.
 Connected to DL output port of H-COM, H-STM or H- DTM.
 Connector Type: SMB-L Female
- UL 1/UL 2
 Outputs uplink signal to H-COM, H-STM or H-DTM
 Connected to UL input port of H-COM, H-STM or H-DTM
 Connector Type: SMB-L Female
- T-SYNC IN
 Receives TDD synchronization signal from H-FEM-B.
 Connected to T-SYNC of H-FEM-B.
 Connector Type: SMB-L Female
 LED
HOM-H
PWR
ALM
KMW
UL1 UL2 DL1 DL2
T_Sync
DL/UL
#1
PWR
ALM
UL1 UL2 DL1 DL2
T_Sync
DL/UL