User's Manual
Table Of Contents
- User Manual
- For
- POD System
- Safety and Regualtion Warning Notice
- 1. POD System Overview
- 2. POD system Components
- 2.1 Head-end Unit
- 2.2 Remote Unit
- 3. Equipment Installation
- 4. Cable Connection
- 5. Specification
User Manual for POD Systems Revision: 0.7
© KMW USA Inc.
1818 E. Orangethrope Ave, Fullerton, CA 92831
Tel. +1 (714) 515-1100
www.kmwcomm.com
87
4.1.6 Cable connection between multiple Racks
Figure 4-6 shows how to connect cable and set rack ID for IP setting.
One H-DMCU is able to control and monitor maximum up to 4 racks and one rack can be composed of
maximum 7 H-SRUs and one H-DMCU. All H-PSU, H-SCM, and H-MCM are connected to H-DMCU through 32
Ethernet ports located in front side of H-DMCU.
Rack ID can be set by dip switch in H-PSU.
- Refer to section 2.1.12.7 to figure out how to set Rack ID.
It might need longer RF cable than RF cable with 35”length included in the packaged box for the connection
between racks. In this case, user needs to buy extra cable with longer length in advance. For your information,
RF cable with 60”, and 90” length can be provided by user’s special order.
Figure 4-6 Connection Diagram for Rack Inter Connection
Rack ID : #3Rack ID : #1 Rack ID : #4Rack ID : #2
Sub-Rack
#1
Sub-Rack
#2
Sub-Rack
#3
Sub-Rack
#4
Sub-Rack
#5
Sub-Rack
#6
Sub-Rack
#7