User's Manual
Table Of Contents
- User Manual
- For
- POD System
- Safety and Regualtion Warning Notice
- 1. POD System Overview
- 2. POD system Components
- 2.1 Head-end Unit
- 2.2 Remote Unit
- 3. Equipment Installation
- 4. Cable Connection
- 5. Specification
User Manual for POD Systems Revision: 0.7
© KMW USA Inc.
1818 E. Orangethrope Ave, Fullerton, CA 92831
Tel. +1 (714) 515-1100
www.kmwcomm.com
77
3.3 Remote Unit
3.3.1 Wall Mount for 3/5/7 band RU and PS700/800 RU
Wall mounting procedure
- Check the suitability of the wall-mounting kit and the wall based on Figure 3-5
Figure 3-5 3/5/7 band RU, PS700/800 RU – wall mount bracket
- Install the wall-mounting bracket using 4 x M10 screw anchors (not included**) according to the drilling
layout. Confirm that the bracket is securely fastened to the wall.
** The M10 screw anchors are not included as part of the RU delivery because the suitable type
depends on the on-site conditions such as wall structure and materials. Therefore, use screw anchors
that are appropriate for the mounting surface.
- Install the Remote Unit on the wall-mounting bracket by lifting the RU into place and lowering it down onto
the bracket. The M6 pins must align with the slots in the bracket to support the RU.
Figure 3-6 3/5/7 band RU, PS700/800 RU – Install RU into wall mount bracket
- Fasten the lower section of the Remote Unit to the bracket using a washer and 2 x M6 screws (on both
sides). Slide a washer over each screw and then insert the screw and tighten it securely.