User's Manual

The information in this document is subject to change without notice

Document Revision V0.61 2013.01.11

Pages

Street Light (HR) Installation & Operation User Guide

Remove the xing bolts in front to lower the lamp

by 5°.

Push the lamp downward whiling aligning its rst

and third bolt holes with the corresponding light

pole holes and bolt parts together for xing like the

following gure:

Put the bolts through the points where both holes

are aligned and tighten them rmly.

STEP. 25

Lamp Angle Control

Use a 17 mm spanner to tighten the xing bolts on

the lamp side. In this case, both sides shall be tight-

ened.

Now, HR Product installation is completed.

Turn the main power switch on to check if the prod-

uct is working properly.

STEP. 26

STEP. 27