Warranty

1
WATCHMAN
®
IV Lock System
ATTENTION: PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS AND WARNINGS
BEFORE ASSEMBLING, INSTALLING OR USING THIS PRODUCT.
WWW.KNAACK.COM
JOBSITE STORAGE SOLUTIONS
Part No. 14-0010 Rev. B 11/11 (ECN 5025)
INSTALLATION MANUAL
– NOTICE –
Any modication or unintended use of this product shall immediately void all manufacturers warranties. Manufacturer disclaims all
liability for injuries to persons or property resulting from any modication to, or unintended use of this product.
INSTALLATION INSTRUCTIONS
NOTE: This lock system is designed to be used with a MASTERLOCK
®
* No. 1, MASTER LOCK No. 5 or AMERICAN LOCK
®
*
No. 50, or an equivalent sized lock. If you are using a padlock not listedabove, it is your responsibility to make sure the lock
mechanism is working correctly. Padlocks must meet ALL requirements listed in Figure 1 or Figure 2.
STEP 1. Unbolt the padlock tab using a 1/2" socket or wrench. Install 5/16" x 3/4" Carriage Bolt into correct hole in Padlock Tab,
install Padlock shackle into Padlock tab then secure to Lock Box using Locking Nut. Do not close the doors. (See Figure 1 or 2.)
TEST THE FUNCTION OF YOUR PADLOCK
(If you have installed one of the padlocks listed above per the instructions, you do not have to perform this test.)
STEP 2. Keep all cabinet doors open, with the padlock in the open position, close only one of the doors. If the latch rod does not
slide up enough for the door to close, the padlock you have installed is not acceptable. If the door does close, push the padlock
into the locked position. Lift up on the latch rod knob and try to open the door. If the door opens the padlock you have installed is
not acceptable.
TOOL REQUIRED
Ratchet Wrench with 1/2" Socket or 1/2" Combination Wrench
Figure 1.
For Installation of Master Lock No. 5, American
Lock No. 50 or equivalent size.
Use round Hole for 3/8” dia.
shackle (Master No. 5,
American No. 5)
Lock Box
Locking Nut
Padlock Tab
1-3/16”
or less
closed
1-7/16” or
more open
Shackle
3/8” dia.
to 11/32”
dia.
7/8” to
1-1/8”
2-1/4”
max.
5/16” x 3/4”
Carr. Bolt
Figure 2.
For Installation of Master Lock No. 1 or
equivalent size.
NOTE: Carriage Bolt will seat into round
hole when tightening Locking Nut.
1-3/16”
or more
open
Locking Nut
Lock Box
5/16” x 3/4”
Carr. Bolt
Padlock Tab
15/16”
or less
closed
2-1/4”
max.
7/8” to
1-1/8”
Shackle
5/16” dia.
or less
Use square Hole for
5/16” dia. shackle
(Master No. 1)
*Master Lock
®
is a U.S. registered trademark of Master Lock Company. American Lock
®
is a U.S. registered trademark of American Lock Company.
*14-0010*