Installation Guide
1
Models 2032, 2048, 2060, 3068
KNAACK
®
Classic Storage Chest
ATTENTION: PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS AND WARNINGS
BEFORE ASSEMBLING, INSTALLING OR USING THIS PRODUCT.
WWW.KNAACK.COM
JOBSITE STORAGE SOLUTIONS
Part No. 14-0014 REV. D ECN 5285 03/13
INSTALLATION AND REPAIR PARTS MANUAL
– NOTICE –
Any modication or unintended use of this product shall immediately void all manufacturers warranties. Manufacturer disclaims all liability for injuries
to persons or property resulting from any modication to, or unintended use of this product.
DANGER
• Do not put fuels, ammables, explosives or hazardous materials inside these products.
• Gasoline, solvents, gun powder or other munitions, dynamite, propane, acetylene or other such products can explode if stored inside these
products.
• Use these products ONLY for storing and transporting electric or hand tools and equipment, and other similar materials.
• Failure to comply could result in death or serious body injury. or porperty damage.
TOOLS REQUIRED
One Wrench with 7/16" Socket
WARNING
Read and understand all instructions and warnings before operating or using this product.
PADLOCK INFORMATION- Padlock with 7⁄8"–1" shackle height (gure 2) (recommended Master No 5 or equivalent, not
included).
STEP 1. Open your padlock and slide the U-bolt over the lock shackle.
STEP 2. Slide the lock through the lock housing on the front of the box (gure 1).
STEP 3. Guide the U-bolt through the two holes in the back of the lock housing (gure 1).
STEP 4. Secure the U-bolt with the two nylon lock nuts supplied.
STEP 5. Repeat the procedure for the second lock.
STEP 6. To lock, close lid and push bottom of padlock until lock “clicks” closed.
STEP 7. To open, turn key and open lid.
INSTALLATION INSTRUCTIONS
®
7/8"-1"
Figure 1
Lock Shackle
Figure 1
U-Bolt
Figure 2
(measure height
when lock is closed)
*14-0014*