Installation Guide

DANGER
IMPORTANT
BEFORE YOU BEGIN
Read these instructions and
warnings completely before
assembly.
ASSEMBLY AND INSTALLATION INSTRUCTIONS
STORAGEMASTER® Rolling Work Benches - Models 4547484950
PARTS LIST
1- Rolling Work Bench
1- Caster Set
1- Handle Kit
4- Drawers (Model 45 only)
0- Drawers (Model 47 only)
2- Drawers (Model 48 only)
8- Drawers & 1- Shelf (Model 49 only)
8- Drawers (Model 50 only)
CASTER BOLT KIT
16 5/16-18 x 3/4" Carriage Bolt
16 5/16-18 Whiz Lock Nut
16 1/4" Pushnut
HANDLE / LIFT KNOB KIT
1 - Push Handle
2 - Door Handle
6 - 5/16-18 x 3/4" Bolt, Truss hd.
4 - 5/16-18 Hex Whiz Nut
1 - Lift Knob
TOOLS REQUIRED
 1/2" Open or Box End Wrench
 1/2" Socket (3/8" drive)
 Medium Extension (3/8" drive)
 Ratchet Wrench (3/8" drive)
 Torque Wrench (ft. lbs.)
 Screwdriver, common
ASSEMBLY INSTRUCTIONS
1. Remove the caster box and handle kit
from the cabinet. Attach Handles to the
doors (Figure 1.). Attach the Push
Handle to the end.
WATCHMAN® III Lock System
IMPORTANT:
Carefully follow the separate instruc-
tions (see inside of door) which will guide
you to a proper lock installation.
Push Handle
5/16-18 x 3/4"
Truss Hd. Bolt
Door Handle
5/16-18 x 3/4"
Truss Hd. Bolt
5/16-18 Whiz
Lock Nut
Figure 1. Assembly View
WARNING
Black knob must be latched
in the closed position when
moving this product, so
doors and drawers do not
open on inclines, which can
cause serious personal
injury or property damage.
Caster Set Installation
2. Close the doors and lay the cabinet
on it's back, onto the flattened shipping
carton to prevent scratches (Figure 2.).
Mount the Swivel Casters on the end
you mounted the Handle. Insert a
Carriage bolt into a mounting hole, and
push a Pushnut onto the bolt to hold it
in place (Figure 3). Repeat this for the
other three mounting bolts. Place the
Caster over the bolts, then fasten with
Whiz Nuts. Repeat this for the remain-
ing Casters.
3.
Stand the unit upright. The Model 45
will now be complete. If you have a
Model 47 or are adding drawers to your
Model 45, read on.
Caster Brakes are not suitable
for keeping units in place when
transporting. Secure by another
method. Do not use casters on
rough or uneven surfaces. Do not
tow caster mounted boxes.
 Do not put fuels, flammables, explosives or hazardous materials
inside these products.
 Gasoline, solvents, gun powder or other munitions, dynamite,
propane, acetylene or other such products can explode if stored
inside these products.
 Use these products ONLY for storing and transporting electric or
hand tools and equipment, and other similar materials.
 Failure to follow these warnings or modification or other uses of
these products could result in death, serious injury or property
damage.
CAUTION
Part No. 14-4710 REV. L ECN 5285 03/13