Installation Guide

1
Caster Sets
ATTENTION: PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS AND WARNINGS
BEFORE ASSEMBLING, INSTALLING OR USING THIS PRODUCT.
WWW.KNAACK.COM
JOBSITE STORAGE SOLUTIONS
ALWAYS ON THE JOB™
INSTALLATION MANUAL
– NOTICE –
Any modication or unintended use of this product shall immediately void all manufacturers warranties. Manufacturer disclaims all liability for injuries
to persons or property resulting from any modication to, or unintended use of this product.
CAUTION
Caster Brakes are not suitable for keeping units in place when transporting. Secure by another method. Do not use casters on rough or uneven surfaces.
Do not tow caster mounted boxes.
Install padlocks in all KNAACK
®
Boxes and lock the covers before laying them on their backs or tops for caster installation. This will keep the covers from
opening and causing possible serious personal injury or property damage as the boxes are laid on their backs. Failure to heed may result in moderate injury.
TOOLS REQUIRED
• 3/8” Drive Ratchet
• 3/8” Extension (6” minimum length)
• 1/2” Socket (for Method 1 mounting)
• 9/16” Socket (for Method 2 mounting)
• 2 Swivel Casters
• 2 Fixed Casters
PARTS LIST
WARNING
Do not exceed load limits, shock or misuse these casters. This cause damage to the caster, causing the caster to collapse and/or the unit to tip
over, causing serious personal injury or property damage. Any worn damaged casters should be replaced immediately. Failure to heed could
result in death or serious injury.
1. When installing on smaller products, lay shipping carton on the oor, and with a minimum of two people, lay the unit on it’s
back to avoid scratching product. On larger products, lift unit with forklift high enough to work at a comfortable height.
2. Decide which end you will steer from. The end you select will have the swivel casters.
3. For Method 1, use bolt kit # 32-0500, thread cutting bolts using the 1/2” socket. Torque bolts to 20 ft. lbs. MAXIMUM.
4. For Method 2, use bolt kit #32-0213 Carriage bolts, nuts and Washers. Tighten fasteners using the 9/16” socket, with
orientation as shown in Method 2 gure above.
INSTALLATION INSTRUCTIONS
BOLT KITS
Two bolt kits have been included with your caster set, depending which type of skid you are mounting to.
3/8” Flat Washer
16
3/8-16 Nylon Lock Nut
16
3/8-16 x 1” Carriage
Bolt
16
BOLT KIT #32-0213 (For Use with Method 2)
3/8-16 x 1-1/2” Carriage Bolt
BOLT KIT #32-0500
BOLT KIT #32-0500 (For Use with Method 1)
5/16”-18 x 3/4” Thread
Cutting Bolt
16
Method 1
Enclosed Skid Mounting
Method 2
4-Way Skid Mounting
CASTER
MODEL
SIZE
MAX. LOAD
RATING
PRE SET
BRAKE
495 4" 1600 Lbs. Yes
695 6" 2600 Lbs. Yes
516
non-marking
6" 2240 Lbs. Yes
Note: Load Ratings are based on caster capacities and
do not necessarily reect load carrying capabilities of
individual KNAACK
®
Products.
ThreadCutBolt,3/4".eps
Part No. 14-0033 REV. C ECN 5305 04/13