Installation Manual

Installation Instructions
Wave Glass Shelf Kit
KT-0134-618ZSN
Tools Required (not included):
- Power Drill
- Screw Driver
- Tape Measure
- Level
Installation Materials (included):
- Wave Glass Shelf
- Mounting Brackets
- Mounting Hardware
Load Rating:
- 25 lbs when mounted onto studs
Installation:
Step 1: Select the desired location to install the wave glass shelf kit. Then locate the
nearest studs in the wall.
Step 2: Place the wave glass shelf on the wall and center it between the studs. Use a level
to ensure it is straight, then gently mark the wall across the top of the shelf in the center
of each stud, as shown in Figure 1.
Step 3: Center the post brackets on each marked line where it intersects the studs,
as shown in Figure 2.
Step 4: Fasten using the mounting screws provided, as shown in Figure 3.
Step 5: Place the wave glass shelf onto the post brackets, as shown in Figure 4.
Figure 1 Figure 2
Figure 4Figure 3
Stud
16"
Level
Stud
Stud
Center
Post Bracket
Drywall
Stud
4"
4"
2700 Oak Industrial Dr. NE
Grand Rapids, MI 49505
800-253-1561
www.kv.com
[e-mail]
©2015 Knape & Vogt. KV and the KV logo are trademarks of Knape & Vogt. 310473/0815