Instruction Manual

FCCWarning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1)thisdevicemaynotcauseharmfulinterference,and
(2) this device must accept any interference received, including interference that may cause
undesiredoperation.
Changesormodifications notexpresslyapprovedby
the party responsible for compliance could
voidtheusersauthoritytooperatetheequipment.
Note1:ThisequipmenthasbeentestedandfoundtocomplywiththelimitsforaClassBdigital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection
against harmful interference in a residential installation. This equipment generates,
usesandcanradiateradiofrequencyenergyand,ifnotinstalledandusedinaccordancewiththe
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does
causeharmfulinterferencetoradioortelevisionreception,whichcanbedeterminedbyturning
the equipment off and on, the user is encouraged to try to correct the interference by one or
moreofthefollowingmeasures:
—Reorientorrelocatethereceivingantenna.
—Increasetheseparationbetweenthe
equipmentandreceiver.
—Connecttheequipmentintoanoutletonacircuitdifferentfromthattowhichthe receiveris
connected.
—Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
Note2:1.Changesormodificationsto this unitnot expresslyapprovedby the party responsible
forcompliancecouldvoidthe
usersauthoritytooperatetheequipment.
2.Theminimumseparationgenerallybeusedisatleast20cm.