CONTENTS BIKE ALARM AND FINDER QUICK START GUIDE KNOG.
WHATS IN THE BOX ENABLE PAIRING Before you can pair the scout to your phone, connect the Scout to a USB charger with a standard USB-C charging cable. SCOUT ALARM AND FINDER *Factory reset the device if it has been previously paired. See page 14 for instructions on how to factory reset your scout device. SILICONE COVER SECURITY TOOL 2 x M5 SECURITY BOLTS 2 x SPACER WASHERS P.3 P.
SET-UP KNOG APP REGISTER DEVICE 1. Find and install the Knog 2. Enter your information to 3. Make sure your Scout is 4. Select device to add “Knog app from the app store create your profile powered, charged and in Scout” range. Click on the + button to search for the scout. P.5 P.
DEVICE CONNECTED 5. Choose a name for your Scout P.7 ARMING + DISARMING FROM PHONE 6. Knog Scout Connected 1. To arm Scout make sure the 2. The Button will now show phone is in range. The Scout the Scout is Armed. should show connected. To disarm, ensure the scout is Click the black button on in range, and press the red screen to arm the Scout button on screen P.
ARMING FROM SCOUT DISARMING FROM SCOUT 1. To arm Scout make sure the The button on the phone will 1. To disarm Scout make sure 2. Click and hold the button phone is in range and the be yellow whilst arming. the phone is in range and the on the Scout to disarm it. Knog app is active on the Knog app is active on the phone. phone. 2. Click the button on the Scout to arm it. The Scout LEDs will now flash until it is armed. Note: Scout cannot be armed unless phone is in very close range. P.
CONNECTING FIND MY CHARGING 1. Open the Find My app by 2. Press ‘Add New Item’ pressing the red arrow button 3. Select ‘Add Other Item’ at the bottom of the screen* 4. When Scout appears, press *To use the Apple Find My app to locate this item, the latest version of iOS, iPadOS, watchOS, or macOS is recommended. 1. Open USB door seal to connect to Find My. Select and name your Scout 2. Plug in USB-C cable to Charge.
DISABLE Find My FACTORY RESET 1. Turn the Scout upside down and place on an horizontal 1. Turn the Scout upside down and place on an horizontal surface (such as a table). surface (such as a table). 2. Press and hold the button for 30 seconds until 4 short 2. Press and hold the button, while plugging in a USB-C cable. beeps are heard. Continue to hold the button for 10 seconds, until 4 short beeps are heard. This procedure will stop sharing the location of the Scout.
SERIAL NUMBER LOOK-UP The Apple Find My app can be used to lookup the serial 3. When the following page is 4. A page similar to this displayed, press the button should be displayed with the on the Scout, then select Scout serial number. If the ‘Continue On Website’ device has been set to lost mode, a message and contact 1. In the Find My app, select 2. Select the item from a list details from the owner may Identify found item, when the of nearby items, then press also be displayed here.
KNOG.COM Use of the Works with Apple badge means that a product has been designed to work specifically with the technology identified in the badge and has been certified by the product manufacturer to meet Apple Find My network product specifications and requirements. Apple is not responsible for the operation of this device or use of this product or its compliance with safety and regulatory standards.
