MedVault ® User Guide Warning Treat this manual as a confidential document. Limit access to authorized personnel. 1601 W. Deer Valley Road, Phoenix, AZ 85027 Phone: 800-552-5669 ● Fax: 623-687-2290 www.knoxbox.
® MedVault User Guide Copyright © 2019 by the Knox Company. All rights reserved. The Knox Company, the Knox logo and all other Knox Company product or service names are registered trademarks or trademarks of the Knox Company. Restricted Rights Legend U.S. GOVERNMENT RESTRICTED RIGHTS. UNPUBLISHED—RIGHTS RESERVED UNDER THE COPYRIGHT LAWS OF THE UNITED STATES. Use, duplication, or disclosure is subject to restrictions set forth in the FAR Section 52.227-14 Alt. III(g)(3), FAR Section 52.
® MedVault User Guide Table of Contents Features ........................................................................................................................................................ 1 Operation....................................................................................................................................................... 2 Release the Door (Non-Group) ................................................................................................................
® MedVault User Guide THIS PAGE INTENTIONALLY LEFT BLANK ■ iv OPE-MVUSER-0129-E
® MedVault User Guide Features ® MedVault is a high security locker for narcotics. Security is ensured through its robust construction and restricted entry. Only authorized users with an administrator assigned personal identification number (PIN) can access the unit. The department administrator maintains all user and PIN information through the Knox Units Administrator software program, which information can be transferred to the MedVault unit.
® MedVault User Guide Operation ® In a secured, stand-by mode, the MedVault unit’s LED banner displays the date, time and a status message of Locked. Release the Door (Non-Group) 1. Enter PIN # on keypad. The LED banner changes to UNSECURE. NOTE: If an incorrect PIN is entered, the LED banner displays Pin Not Found. Repeat step 1 using a correct PIN. 2. Turn the knob counter-clockwise (left) and open the door. The LED banner then displays the date, time, and a status message of Unlocked::Sol Swch.
® MedVaulti User Guide Log out of Groups System security is maintained by the group master logging out of a unit at the end of a shift or specific time frame. To log out of a group, enter * (master) PIN # on the keypad. The LED banner displays Logged Out. NOTE: It is not necessary for a group master of several groups to log out in order to change groups. Drug Inventory Use the following instructions to update or decrease a unit’s drug inventory. Change Drug Inventory 1. Enter * * 1 # on the keypad. 2.
® MedVault User Guide Unit Access during Power Failures The manual key lock should be used during a power failure, since the LED keypad will not operate without power. Display Messages ® The MedVault scrolling banner provides information about the current status of the unit.
