EX-NEXT Manual

11
●Steering Wheel Adjustment
●Throttle Trigger Adjustment
●
Adjustment of the decrease angle adjuster
●Throttle Trigger Position Adjustment
●Adjustment of Trigger Tension
●ET Keys (1-5) and BT Button (1)
Adjust the tension of the steering wheel spring.
Functions may be assigned to the keys/button. For key
allocation, please refer to KEYSET key conguration (p.31).
Adjust the position and angle of the brake trigger to your
preferences.
The position of the throttle trigger may be adjusted to match
the user's hands.
Insert a 1.5mm hex wrench referring to the image below.
Rotate clockwise to increase tension and counterclockwise
to decrease it.
<How to Adjust>
Loosen the hex screws on the throttle trigger with a
1.5mm hex wrench.
Freely adjust the brake trigger position.
Tighten the hex screws to secure.
The steering sponge is removed.
Using a 2mm hexagonal wrench, insert into the two
holes of the steering wheel to adjust the angle you
prefer.
Perform the VR information conguration (p.17).
Replace the steering wheel sponge.
Loosen two screws on the rear side of the transmitter.
Slide the Throttle Trigger Position Adjuster as desired.
Tighten the loosened screws to secure.
<How to Adjust>
<How to Adjust>
Excessive counterclockwise rotation will result in the wheel being
unable to return to neutral position. In this case, rotate clockwise
until the wheel returns to neutral
The possible functions which each key/button may be
assigned to are different.
The trigger may loosen over time due to temperature, usage,
strong impacts, etc., we recommend you glue it in place. When
there are times that it is still loosens, please inquire to our service
department.
Hex Wrench
Throttle trigger
Brake lever
Throttle lever
Screws
Hex screws
Ball Joint
Throttle Trigger
Position Adjuster
Strength (tension) of the spring for the throttle trigger is
adjustable.
* Only Expert grip unit available.
Using a 1.5mm hexagonal wrench (not included) insert into the
lower part of the grip section. When turned clockwise (right) the
tension becomes stronger, counter-clockwise (left) it becomes
less.
<How to Adjust>
Hold the trigger lightly, insert the hexagonal wrench.