EX-NEXT Manual

BATT
BATT
点灯
19
●Pairing
(for general RC car)
①.Turn off the transmitter and turn on again.
①.Check that the receiver's LED lights up again (indicating
pairing completion)
Press the Back key in the EX-NEXT.
Check that the receiver's LED lights up again (indicating
pairing completion)
Preparing the transmitter.
Preparing the transmitter.
①.Press ENT key when FUNCTION is selected at the Initial
screen.
While pushing the ET2 lever up, power on. The pilot LED
lights up, release ET2 lever.
Please release the ET-2 lever when the initial screen is
displayed.
A case of pairing method with changed RF mode.
A case of pairing method without changed RF mode.
Preparing the receiver
Preparing the receiver
<Pairing Method 2>
<Pairing method 1>
<Pairing method 1 and 2 comon.>
①.Press ENT key when TLMY is selected at the FUNCTION
menu.
①.Move the cursor to PAIRING and press and hold ENT key.
①.Screen is change to the PARING and start sending the pairing
signal.
①.Receiver's LED lights up again (about
3sec) and light off and start ashing. It
means searching for transmitter signal.
①.Press ENT key when RFMODE is selected at the Telemetry menu.
①.Please set the RF MODE and WIDTH in the RF MODE
menu for you needs.
Change to pairing screen and start transmit power with
paring signal.
Change to pairing screen and start transmit power with paring signal.
ADV: Green / White TLMY: Blue / White
The EX-NEXT LED lights alternately in two colors
corresponding to
ADV: Green / White TLMY: Blue / White
This operation allows the receiver to memorize the transmitter information. You must perform this when using a
receiver for the rst time or when changing the EX-NEXT RF mode.
*There are two ways of pairing a receiver. Please use which ever method you feel is an easier operation.
1. 1.
2.
2.
3.
3.
ET2
Power ON
↓
↓
↓
MONITOR XT-TMG DR5.8V
MODEL NO.01
STEERING
THROTTLE
FUNCTION
STEERING
THROTTLE
TIMER タイマー
TIMER
OFF
OFF
TIMER START
TRG START
LAP HISTORY
START/STOP KEY
LAP KEY
RF MODE
RF MODE:
WIDTH :
TLMY
GENERAL
PAIRING
FUNCTION
MODEL
3 - 8CH
TIMER
KEYSET
TLMY
SYSTEM
TELEMETRY
RELICS
BT F/S
RESP
RFMODE
①.Turn on the receiver. And thereceiver's LED
will be start ashing.
①.Check that the receiver's LED has lit up,
then release the setup button
①.Check that the receiver's LED lights up again
(indicating pairing completion)
Preparations for Operation
Preparations for Operation
If the LED ashes, the receiver is not getting
the EX-NEXT signal and the pairingprocedure
should be repeated.
①.
Connect the receiver power source
while pressing the setup button.
①.
Check that the receiver's LED has lit up,
then release the setup button.
①.
Check that the receiver's LED lights up
again (indicating pairing completion
①.
Receiver's LED lights up again (about
3sec) and light off and start ashing.
It means searching for transmitter
signal.
Lit LED
Lit LED
Flash