EX-NEXT Manual

CarbonFiberChassis
Noise is generated in any area where a large amount of electric
current is flowing. Position the receiver and antenna cable as far
away from the motor, battery, ESC,
and their associated cables as possible. (Metal or carbon fiber
chassis components will also conduct electricity and generate
noise.)
Since R/C models are controlled via radio signals, taking appropriate
measures against noise generated by on-board equipment is of
utmost importance. Take adequate measures against noise so that
your machine can fully realize your driving potential.
Battery
Receiver
ESC SiliconCables
Motor
Noise
Noise
Noise
Noise
Noise
Noise
Noise
Noise
Noise
Noise
Keep antenna cable away from all sources of noise!
When installing the receiver to the chassis or R/C
equipment deck/tray, use two or more pieces of thick
double-sided tape to raise the receiver off the chassis
surface. By increasing the separation between the
receiver and the noise-generating carbon-fiber chassis
components, the effects of noise can be decreased.
Raise the antenna cable vertically from as high a position as possible. Insert the antenna cable into the antenna pipe so that the tip
of the antenna aligns with the end of the pipe. Make the length of cable which runs between the receiver and the pipe as short as
possible and position the antenna holder as close to the receiver as possible. Position the antenna cable away from sources of
noise such as the chassis and R/C equipment deck/tray. Use an antenna pipe and antenna mount that are made from plastic, since
metal parts will conduct noise.
Engine vibrations may damage the receiver. Make sure to attach a
grommet (receiver holder) to reduce the effects of such vibrations.
Do not attach the receiver directly to the chassis or R/C equipment
deck/tray with double-sided tape. Also position the receiver so that it
does not contact the heat and exhaust of the engine and muffler.
Plastic
Antenna Pipe
Plastic
Antenna Pipe
Plastic
Antenna Holder
Grommet
Aluminum Antenna Holder
Aluminum Antenna Holder
Piano Wire
Double-Sided Tape
Antenna Cable
Signal Receiving Section
Noise
Noise
Noise
Noise
Noise
Noise
ノイズ
Noise
(Acceptable with FRP
or plastic chassis)
Soldered Lug Plate
● Receiver Installation on a Carbon Fiber Chassis
● Antenna Installation
● Installing Onto a Glow Engine Car
*Install the receiver so that its LEDs are visible.
*Install the receiver so that its LEDs are visible
*Do not bend or cut the antenna cable.
(This may break the antenna wire and deteriorate its performance.)
20
●Countermeasures Against Noise