EX-NEXT Manual

1
2
3
4
21
Fail-safe is when the receiver loses the radio signal of the transmitter and the function keeps channel 2
(throttle) in an optional position. The conguration is usually full brake or neutral.
Fail-safe function will be cancelled automatically when the receiver receives the signal from the transmitter.
to the 2 channel
B/S
Press hold over 3 sec
Release button after light goes
off.
Full Brake
Neutral
Turn on.
Turn ON
Connect a servo or ESC to 2Ch on the
receiver which you want to set the fail-safe
setting.
Turn off the transmitter to check the
Fail-safe setting is correct and safe.
Press and hold the setup button longer
than 3 seconds while holding the position
of the throttle trigger to the desired Fail-
safe position at the same time.
Please release the setup button on the
receiver after the LED light goes off.
The setting is saved when the LED light
comes back on again.
We recommend setting the throttle
position for Fail-safe as listed below.
•When using an ESC with reverse
:Neutral
•Gas powerd car
•ESC only forward
:Neutral or Full brake
Turn on the transmitter.
Turn on the receiver and check that each
device connected operates correctly.
After Pairing
Hold the throttle
trigger to the position
you want to set for
Fail-safe.
●Fail-Safe Setting
If you change the position of the fail-safe operation, please set
again. We recommend to set it again even. if you modify the
car engine brake linkage.
Please be sure to set the fail-safe.