EX-NEXT Manual

22
*This can be set when using TLYM mode.
*Also if you change the RF-mode to XT-ADG or XT-ADF after this setting, the setting stays activated.
The battery fail-safe function allows the automatic decelerate or brake when the voltage of the receiver battery falls below the
set voltage. When the fail-safe function is activated, the set servo is automatically operated to any position (the position set by
the fail-safe function). When the voltage is restored, the battery fail-safe function will automatically cancel.
*The purpose of using the battery fail-safe function is to stop using a damaged or weak battery by mistake.
We do not recommend using this as a safe function to determine a dead battery.
* This function is used for gas powered cars only. Do not use this function for EP cars.
●Battery fail safe setting
Select FUNCTION in the initial screen
Select TLMY in the Function menu.
Select VIBRATOR in the ALERT MODE.
FAIL SAFE Voltage
Select ALERT (Voltage)
Select BT F/S in the Telemetry.
MONITOR XT-TMG DR5.8V
MODEL NO.01
STEERING
THROTTLE
FUNCTION
STEERING
THROTTLE
TIMER タイマー
TIMER
OFF
OFF
TIMER START
TRG START
LAP HISTORY
START/STOP KEY
LAP KEY
BATTERY FAIL SAFE
CURRENT :
ALERT :
FAIL SAFE :
ALERT MODE: VIBRATOR
MINIMUM :
MAXIMUM :
8.1V
6.0V
7.1V
8.2V
5.8V
CLR
TIMER タイマー
TIMER
OFF
OFF
TIMER START
TRG START
LAP HISTORY
START/STOP KEY
LAP KEY
BATTERY FAIL SAFE
CURRENT :
ALERT :
FAIL SAFE :
ALERT MODE: VIBRATOR
MINIMUM :
MAXIMUM :
8.1V
OFF
7.1V
8.2V
5.5V
CLR
TIMER タイマー
TIMER
OFF
OFF
TIMER START
TRG START
LAP HISTORY
START/STOP KEY
LAP KEY
BATTERY FAIL SAFE
CURRENT :
ALERT :
FAIL SAFE :
ALERT MODE:
MINIMUM :
MAXIMUM :
8.1V
6.0V
5.8V
7.1V
8.2V
VIBRATOR
CLR
FUNCTION
MODEL
3 - 8CH
TIMER
KEYSET
TLMY
SYSTEM
TELEMETRY
RELICSRESP
RFMODE
BT F/S
Reference value : Life 5.2V
Lipo 6.0V
Will be informed by vibration or buzzer when
voltage were lower from setting value.
Reference value: Life 5.0V
Lipo 5.8V
Fail-safe function will be active when the
voltage is lower then the setting value.
Change to VIBRATOR (recommend setting) or
BUZZER in the Alert Mode.
This mode will be active when the ALERT setting is
reached.