EX-NEXT Manual

24
When using the battery fail-safe or when there is a system
problem, you can check this error using this screen.
Press and hold the BACK key from the initial screen and the
display is change to Error status display. This screen will return
to the initial screen automatically after a few seconds.
In telemetry mode, when the receiver signal is received,
the LED lights up alternately between red and blue.
When the Steering unit is not connected properly the LED
lights up Red.
Error display1
<Case when can not receive signal from receiver.>
COMMUNICATION: Can not communicate to the receiver.
EEPROM: Memory has been corrupted.
BODY UNIT: Contact failure with Master Unit.
STEERING UNIT: Steering unit is not connected.
Error display2
<Case when signal is received from receiver.>
RECEIVER VOLTAGE: Voltage is under the set voltage.
RECEIVER FAIL-SAFE: Battery fail safe is working.
●Master unit Update ●ERROR Status
TIMER タイマー
TIMER
OFF
OFF
TIMER START
TRG START
LAP HISTORY
START/STOP KEY
LAP KEY
ERROR STATUS
COMMUNICATION:
EEPROM :
BODY UNIT :
STEERING UNIT :
RECV ERROR
TIMER タイマー
TIMER
OFF
OFF
TIMER START
TRG START
LAP HISTORY
START/STOP KEY
LAP KEY
ERROR STATUS
RECEIVER VOLTAGE :
RECEIVER FAIL SAFE :
LOW
ACTIVE
EX-NEXT is able to update software by our
supplied files on our website.
Also, details of the procedure will be released on
the website.
Please check our site.
https://www.kopropo.co.jp