EX-NEXT Manual

34
3-8CH
LEFT−ST
RIGHTー ST
NORM
L・SPEED100％
L・RIGHT70％
（１CH）
R・LEFT 70％
R・SPEED100％
R・RIGHT70％
L・LEFT 70％
L・TRIM 0
R・TRIM 0
3CHMODE：TWINSERVO
->KEY:OFF
TRVL100
RIGHT70
LEFT70
CENTER0
REVERSENORM
MODENORMAL
->KEY:OFF
->KEY:OFF
3CHMODE：４WS
TWIN SERVO 4WS
This function modies the setting for using 2 steering servo.
Using left steering servo 1ch, and right steering servo 3ch or
4ch.
This function is related to an R/C car's 4-wheel steering
feature. If 3CH or 4CH is assigned to control the rear axle, it
will operate in conjunction with 1CH (steering). The direction of
the rear axle steering may also be changed.
Setting Value
LEFT-ST (1CH)
L-LEFT : 30 - 100% (Default : 70%)
Sets the highest value for the 1CH servo left operation.
L-RIGHT : 30 - 100% (Default : 70%)
Sets the highest value for the 1CH servo right operation.
L-SPEED : 1 - 100% (Default : 100%)
Sets the steering speed for the 1CH servo operation.
L-TRIM : 50 - 50 (Default : 0)
Sets the neutral position for the 1CH servo operation range.
RIGHT-ST
NORM(Normal),REVS(Reverse) (Default : NORM)
Sets operation direction of 3CH or 4CH servo.
R-LEFT : 30 - 100% (Default : 70%)
Sets the highest value for the 3(4)CH servo left operation
R-RIGHT : 30 - 100% (Default : 70%)
Sets the highest value for the 3(4)CH servo right operation.
R-SPEED : 1 - 100% (Default : 100%)
Sets the steering speed for the 3(4)CH servo operation.
R-TRIM : -50 - 50 (Default : 0)
Sets the neutral position for the 3(4)CH servo operation range.
Setting Range
MODE (Default: NORMAL)
NORMAL : front and rear axles turn in the same direction
REVERSE : front and rear axles turn in opposite directions
F STEER : steer front axle only
R STEER : steer rear axle only
LEFT : 0 - 100 (Default: 70)
Adjusts the rear axle servo movement range when steering is
turned to the left.
CENTER : -50 - 50 (Default: 0)
Adjust the rear axle servo's neutral position.
RIGHT : 0 - 100 (Default: 70)
Adjusts the rear axle servo movement range when steering is
turned to the right.
TRAVEL : 0 - 150 (Default: 100)
Adjusts the overall amount of movement of the rear axle
servo when the steering is at full lock.
REVERSE : NORM,REVS (Default : NORM)
Sets operation direction of 3CH or 4CH servo.
MODE >> KEY : OFF,ET1 - 5 (Default : OFF)
Assigns ET keys to be used for 4WS Mixing MODE.
CENTER >> KEY : OFF,ET1 - 5 (Default : OFF)
Assigns ET keys to be used for 4WS Mixing CENTER.
TRVEL >> KEY : OFF,ET1 - 5 (Default : OFF)
Assigns ET keys to be used for 4WS Mixing TRAVEL.
Example
Ackerman control is possible when using for drift cars using
twin servos.
3

・4CH
3

・
4CH