EX-NEXT Manual

38
TELEMETRY
RELICS
BT F/S
RESP
RFMODE
TLMY Teremetry
RESP Response
Sets the servo response mode. *Only radio mode TLMY can use this function.
TIMER タイマー
TIMER
OFF
OFF
TIMER START
TRG START
LAP HISTORY
START/STOP KEY
LAP KEY
RESPONSE SET
CH1:
CH2:
NORM
NORM
CH3:
CH4:
NORM
NORM
Setting Range
RESP : HCS/NORM/MILD(Default : NORM)
●Response mode setting example
It can be used to adjust the response speed of Servo (ESC).
HCS :The most responsive and high-denition maneuvering
characteristics. *HCS compatible servo is required.
NORM: Intermediate maneuvering characteristics
MILD : Steering characteristics with gentle response.
P
The response set in TLMY mode is valid even if you switch to
ADV/MX-F.For example, if you set HCS to 1CH, switch to ADV,
and connect a servo that does not support HCS, the servo may be
damaged.Response settings other than TLMY cannot be checked
or changed, so check the settings of each CH carefully.
When using with ADV, 4S or HCS servo is recommended.
Please use TLMY for non-compatible servos.
If you connect serially to the B / S port, the response settings will
be invalid.
The response setting is valid only for 1 to 4CH connections.
*When ADV and NORM are combined according to the
specications, the operating range is limited.
The maximum operating angle is limited to about 42 ° on
one side only. Throttle travel (F or B) only works up to
around 97.
Steering travel (L or R) only works up to around 138.
(When the balance is 70 (default))
The output shaft of some servos may vibrate near the limit
angle. In this case, change the response to MILD or RF
mode to TLMY.
ADV
SERIAL
1CH：HCS
B/S
1CH/ID1:
Steering
B/S
1CH/ID1:
Steering
B/S
1CH/ID1:
Steering
2CH/ID2:
Throttle
2CH：HCS
2CH：HCS 2CH：HCS
1CH：HCS 2CH：HCS
TLMY
GPCar EPCar
1CH：HCS 2CH：MILD 1CH：HCS 2CH：NORM
1CH：MILD 2CH：MILD
2CH：MILD
B/S
ID1:
Steering
1CH：NORM 2CH：NORM
2CH：NORM
ADV
1CH：HCS 2CH：NORM 2CH：NORM
2CH：NORM
2CH：NORM
B/S
ID1:
Steering
2CH：NORM
1CH：HCS
TLMY
2CH：NORM
1CH：MILD 1CH：NORM
NOR
ESC
ESC
ESC
ESC
ESC
ESC
NOR NOR
NOR
NOR
NOR NOR
NOR
NOR
NOR
NOR
It means incompatible servo for HCS or serial