EX-NEXT Manual

41
SYSTEM 1/2
CALC.
SOUND
BATTRY
VRINFO
DISPLAY
CONFIG
FUNCTION
MODEL
3 - 8CH
TIMER
KEYSET
TLMY
SYSTEM
DISPLAY ガメン
CONTRAST ノウド
LIGHTMODE
LIGHTTIME ライトタイム
4
5
バックライト
KEY-ON
',63/$<ؙ
CONTRAST
LIGHTMODE
LIGHTTIME
4
5
KEY-ON
DRY
LIPO
NI-MH
LIFe
BATTERY
DISPLAY
BATTERY
You can make various settings related to the system.
You can set the LCD monitor.
Select the type of battery to use.
When the backlight is set to KEY-ON, it lights up when the keys
(ET, BT) are operated. It does not light when steering or throttle
operation.
After changing the battery / battery, be sure to
check the battery type. !!
If the settings are different from the battery you are using, it will
over-discharge and damage the battery. Please be careful as it
may cause a re.
As a characteristic of liquid crystal displays, they tend to appear
darker when it gets warmer and lighter when it gets colder. You
don't have to adjust it often. If you are concerned about the display
density, adjust it.
P
By specifying the power supply (battery type) to be used, a warning
message is displayed before the discharge termination voltage.
The transmitted signal will not be cut immediately, but it may cause
control problems, so charge it immediately or replace the battery.
If you accidentally set the battery type, you can
press and hold the BACK key to cancel the warning
message and display the initial screen. Reset to the
correct battery.
Example)
When using a dry battery, the LIPO mode is selected
and the operation stop mode cannot be exited.
P
P
SYSTEM
Setting Range
CONTRAST : 1 - 5(Default : 4)
Adjust the display density.
Decrease the number to make it lighter, and increase it to
make it darker.
Setting range
DRY (alkaline batteries)
Warning buzzer 4.0V or less
Warning buzzer / stop operation 3.8V or less
LIFe (lithium ferrite battery)
Warning buzzer 6.2V or less
Warning buzzer / stop operation 6.0V or less
NI-MH (nickel metal hydride battery)
Warning buzzer 4.0V or less
Warning buzzer / stop operation 3.8V or less
LIPO (lithium polymer battery)
Warning buzzer 7.0V or less
Warning buzzer / stop operation 6.0V or less
LIGHTMODE
Back light mode : OFF, ON, KEY-ON
(Default : KEY-ON)
Set the lighting method.
OFF : Always off ON : Always on
KEY-ON : Lights when a key is operated
LIGHTTIME : 1 - 60 (Default: 5)
When the backlight mode is KEY-ON, specify the time
(seconds) for temporarily turning off the backlight after
stopping key operations (other than steering and throttle).