EX-NEXT Manual

Neutral
Right
Max
Left
Ma
x
Neutral
Right
Max
Left
Max
→
Neutral
ET1
Right
Max
Left
Max
STEERING
TRAVEL
DYNAMC
TRIM
SPEED
FEEL
REVERS
ET1
ET1
ST REVERSE
TH REVERSE
REVS
NORM
REVERSE
9
The following function explanation is the case of factory
default settings. When changing KEYSET (key setting); the
following opinions change.
Turn the steering wheel in the right and left directions
to verify the servo (steering) connected to 1CH of the
receiver is operating.
Adjust the left/right steering angles independently.
This enables the turning radii to match up during cornering.
● Balance R(Right)
Hold steering wheel to all the right.
Push ET1 lever by 1 click, adjust the range of Steering
angle.
● Balance L(Left)
Hold steering wheel to all the Left.
Push ET1 lever by 1 click, adjust the range of Steering
angle.
Changing the output directional movement of the servo
when it is moving in the opposite direction.
(when a steering moves to the left while turning the
steering wheel to the right.)
Adjusts the neutral/center position of the steering angle
range. The function to make a ne adjustment so that a
car goes straight, operate the ET1 lever in the right and
left directions.
● A buzzer sound with a single beep sound when operated
to the right and left.
● A buzzer sound "Piro" is made when the center trim is
adjusted.
●When exceeding the setting range a "Pi-" sound can be
heard. Please look over your installation and linkage of
the servo horn.
<ex: Right>
■Steering Wheel
■Steering Balance
■Steering Reverse
■Steering Trim
●STEERING
Select [STEERING] on the initial screen and push
ENTER key.
Change setting from NORM to REVS.
Select [REVERSE] on the STEERING menu, and push
ENTER key.
MONITOR XT-TMG DR5.8V
MODEL NO.01
STEERING
THROTTLE
STEERING
FUNCTION
THROTTLE
Hold steering wheel
to all the right
Hold steering wheel
to all the left
■ Basic operation■ Basic operation
To adjust the amount of steering for right and left at
one time, change steering travel (p.46) with ET4 dial.
The above function can be invalidated by turning "OFF"
direct balance (p.46).
P
P
* Return reverse setting, perform operation to to again.