Operating Guide

OPERATING INSTRUCTIONS

WARNING

• If any parts are damaged or missing, do not operate this product until the parts are replaced.

Failure to heed this warning could result in serious personal injury.

• Do not attempt to modify this product or create accessories not recommended for use with this

leading to possible serious personal injury.

• Do not allow familiarity with this product to make you careless. Remember that a careless fraction

• Always wear safety goggles or safety glasses with side shields when operating power tools.

Failure to do so could result in objects being thrown into your eyes, resulting in possible serious

injury.

• Do not use any attachments or accessories not recommended by the manufacturer of this product.

The use of attachments or accessories not recommended can result in serious personal injury.

Adding bar and chain lubricant

Use a bar and chain lubricant (not included) with this

product. It is designed for chains and chain oilers,

and is formulated to perform over a wide temperature

range with no dilution required.

Note: Chain saw comes from the factory with no bar

and chain oil added.

The level should also be checked after every 20

• Remove oil cap (N).

• Carefully pour the bar and chain oil into the tank.

• Wipe off excess oil and replace cap.

•

indicator is below the MIN. line.

• Repeat as needed.

Note:

• Do not use dirty, used or otherwise contaminated oils. Damage may occur to the bar or chain.

• It is normal for oil to seep from the saw when not in use. To prevent seepage, empty the oil tank

after each use then run for one minute. When storing the unit for a long period of time (three

months or longer) be sure the chain is lightly lubricated; this will prevent rust on the chain and bar

sprocket.

IMPORTANT

To preserve natural resources, please recycle or dispose of oil properly. Consult your local waste

authority for information regarding available recycling and/disposal options.

Oil indicator