Operating Guide

A. To start the chain saw:

• Make sure chain tension is at desired setting. Refer to

adjusting the chain tension in the Care and

Maintenance section of this manual.

• Make sure the chain cover lock knob is tight to the

chain cover.

• Make sure no objects or obstructions are in the

immediate vicinity which could come in contact with

the bar and chain.

• Fit the battery into the chain saw.

• Press in the safety lock (E). This makes the trigger

(F) operational.

• Press and hold the trigger (F) and keep it

pressed for continued operation.

B. To stop the chain saw:

• Release the trigger (F).

OPERATING INSTRUCTIONS

Keep body to the left of the chain line. Never straddle the saw or chain, or lean over past the chain line.

WARNING

Starting and stopping the chain saw

Preparing for cutting

A. Proper grip on handles

See General Safety Rules for appropriate safety equipment.

• Wear non-slip gloves for maximum grip and protection.

•

left hand on the front handle and your right hand on

the rear handle so that your body is to the left of the

chain line.

• Maintain a proper grip on the saw whenever the motor

the thumb is wrapped under the handlebar. This grip is

least likely to be broken by a kickback or other sudden

reaction of the saw. Any grip in which the thumb and

dangerous because a slight kick of the saw can cause

loss of control.

Upon release of the trigger, the safety lock will be automatically reset to the lock position.

Note: It is normal for the chain to coast to a stop once the trigger is released.

Proper hand

grip position

Chain line

Proper grip

Improper grip