Operating Guide

13
ASSEMBLY INSTRUCTIONS
5c
5. To install the cutting line
Do not put more than 15 feet of cutting line
Note:
a. Line up the slots on the bump knob (P) with the
slots on the spool cover (L).
b. Insert line through the eyelet (N). Push
line until it exits the opposite string head hole.
c. Pull the line through until there is an equal amount
of line on each side.
d. Turn the bump knob (P) clockwise to begin winding
the string into the string head (S). Leave
approximately 5 inches of string protruding out of
each side of the head.
5a
5b
in at a time.
L
N
P