Operating Guide

13
OPERATING INSTRUCTIONS
Starting and stopping
A. To start the motor:
• Insert the battery pack (not include) into the pole saw.
Press and hold the safety lock-off button (J).
This makes the trigger (K) operational.
•
Press and hold the trigger (K), release the
safety lock-off button (J) and continue to squeeze
the trigger (K) for continued operation.
Preparation for cutting
• Wear non-slip gloves for maximum grip and protection.
•
•
on the rear handle so your body is to the left of the chain line. Never use a left-handed (cross-
handed) grip, or any stance that places your body or arm across the chain line.
• Never stand directly under the limb you are cutting.
• Be certain the couplers are fully tightened before operating equipment; check them periodically for
tightness during use to avoid serious injury.
Basic cutting procedure
Follow the steps below to prevent damage to tree or shrub bark. Do not use a back-and-forth sawing motion.
•
or trunk.
•
through the limb until the limb separates from the tree. Be prepared to balance the weight of the
tool when the limb falls.
•
J
K
•
B. To stop the motor:
• Release the trigger.