Operating Guide

ASSEMBLY INSTRUCTIONS

1. Connecting the poles

a. Insert the extension pole (C) into the handle pole (B) and

slide together.

b. Lower the collar (I) on the extension pole (C) to the

threaded base on the handle pole (B) and rotate

clockwise to secure.

c. Repeat this process to attach the extension pole (C) to

the power head pole (D).

WARNING

Periodically check the connections to ensure that they are

tightened securely.

2. Adding bar and chain lubricant

Use a bar and chain lubricant (not included) with this

product. It is designed for chains and chain oilers,

and is formulated to perform over a wide temperature

range with no dilution required.

Note: This pole saw comes from the factory with no bar

and chain oil added.

The level should also be checked after every 20 minutes

of use and relled as needed.

• Flip up the tab and twist to remove the oil cap (K).

• Carefully pour the bar and chain oil into the tank.

• Wipe off excess oil and replace cap.

• Check and ll the oil tank when quick view oil

indicator is below the MIN. line.

• Repeat as needed.

Note:

• Do not use dirty, used or otherwise contaminated oils. Damage may occur to the bar or chain.

• It is normal for oil to seep from the saw when not in use. To prevent seepage, empty the oil tank

after each use then run for one minute. When storing the unit for a long period of time (three

months or longer) be sure the chain is lightly lubricated; this will prevent rust on the chain and bar

sprocket.

WARNING

To preserve natural resources, please recycle or dispose of oil properly. Consult your local waste

authority for information regarding available recycling and/disposal options.

3. Battery

IMPORTANT: The battery may not be fully charged when purchased. Before using the pole saw

for the rst time, place the battery in the battery charger and charge. Make sure to read all safety

precautions, and follow the instructions in the battery and charger manuals.

Oil Indicator