Use and Care Guide

10
kobalttools.com
OPERATING INSTRUCTIONS
1. To Charge a Battery Pack
NOTICE: Battery packs are shipped in a low charge condition to
prevent possible problems. Before using it the rst time, fully charge
the battery pack. Refer to the operating manual for your battery
pack to determine charging times.
a. Charge the battery pack with the correct charger.
b. Connect the charger to a power supply. The red and green
LED charge indicators (B and C) will illuminate approximately
1 second then turn off.
c. Attach the battery pack
to the charger by aligning
the raised ribs of the
battery pack with the slot
in the charger. Slide the
battery pack onto the
charger (Fig. 1).
d. The charger will
communicate with the
battery pack’s circuitry to
evaluate the condition of
the battery pack. Please
refer to the Charger
Display section.
e. The green LED will ash continuously during normal charging.
f. After charging is complete, the green LED on the charger will be
on and the power indicator LEDs on the battery pack will turn off.
The power indicator LEDs will illuminate when the power indicator
button is pressed while the battery pack is off the charger.
1