Use and Care Guide

15
TROUBLESHOOTING
WARNING
• Turn the switch to the “OFF” position, press the switch lock button to lock it and remove the
battery pack from the reciprocating saw before performing troubleshooting procedures.
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
The reciprocating
saw does not work.
Battery is depleted. Charge the battery.
Blade binds, jams, or
burns the wood.
1. Improper operation . 1. See “OPERATING
INSTRUCTIONS” section.
2. Dull blade. 2. Replace or sharpen blade.
3. Improper blade. 3. Replace blade.
Blade cannot be
removed.
Saw dust in the blade
clamp slot.
Clean the clamp slot with brush.
Saw vibrates or
shakes.
1. Damaged blade. 1. Replace blade.
2. Loose blade. 2. Remove the blade and reinstall it.
The LED worklight
blinks rapidly.
The tool has stopped
working to protect internal
circuits.
Release the trigger switch, wait for
the tool to cool down, then start the
tool again.
The LED worklight
blinks slowly.
The battery charge is very
low.
Charge the battery.
WARRANTY
For 5 years from the date of purchase, the reciprocating saw is warranted for the original
purchaser to be free from defects in material and workmanship. This guarantee does not
cover damage due to abuse, normal wear, improper maintenance, neglect, unauthorized
repair/alteration, or expendable parts and accessories expected to become unusable after a
reasonable period of use.
If you think your product meets the above guarantee criteria, please return it to the place of
purchase with valid proof of purchase and the defective product will be repaired or replaced at
no charge. This guarantee gives you specic legal rights, and you may also have other rights
that vary from state to state.