Operating Guide

12
Always remove battery from your tool when you are assembling parts, making adjustments, cleaning,
or when not in use. Removing battery will prevent accidental starting that could cause serious
personal injury.
6a. TO INSTALL BATTERY PACK
• Open the battery compartment cover (G).
• Align the battery (V) with the cavity in the snow
thrower housing.
• Insert the battery into the right battery
compartment when standing in the operating
position to start the snow thrower. This snow
thrower is equipped with a battery storage
compartment to store an extra battery pack to
extend your runtime.
• Slide the battery down to lock it into position.
The battery is fully inserted into the snow
thrower when you hear an audible “click”.
• Close the battery compartment cover.
5b. TO REMOVE BATTERY PACK
• Release your grip on the bail lever to stop the
snow thrower.
• Press the battery release button in the snow
thrower housing. This will cause the battery to
raise out of the tool slightly.
• Remove battery pack from the snow thrower.
6
WARNING
G
V
5
5. INSTALLING THE DISCHARGE CHUTE
• Align the grooves of the discharge chute (F)
with the slot on the chute housing.
• Push the discharge chute into position.
• Tighten the discharge chute screws (DD) with a
Phillips head screw driver to lock the discharge
chute.
F
DD
Groove
Slot
Battery
release
botton