Operating Guide

kobalttools.com
12
ASSEMBLY INSTRUCTIONS
4b. To replace the spool:
a. Replace the spool (M) with a new pre-wound
spool (not included) or a re-wound spool.
b. Insert the ends of the line through the line
openings in the spool housing.
c. Align the tabs on the spool cover (L) with the slots
in the spool housing (O) on the trimmer head.
d. Push down on the spool cover (L), locking it to the
spool housing (O).
e. To advance the line when initially installed, pull the
line while pressing the line release button on the
side of the spool housing (O).
4c. To
the spool:
a. Cut a length of 0.065 in. (1.65 mm) nylon
b. Insert end of line into the small hole to anchor
the line.
c.
direction. Once completed, put the line in the slot
so it does not unwind. Repeat for the remaining
spool section.
d. Do not wind the line beyond the edge of
the spool (M).
M
O
L
4a
4b
4c
4. Cutting line
on the grass trimmer/edger. When the cutting line
needs replacing, insert a new spool (not included)
or rewind new line onto existing spool.
CAUTION: To avoid injury, always remove
the battery before installing the guard, changing a
cutting line, or making any adjustments.
4a. To remove the spool:
a. Remove the battery from the trimmer.
b. Turn the string trimmer/edger over to access the
spool.
c. Remove the spool cover (L) by pressing on two
tabs parallel to each other on the side of the
spool cover (L).
d. Remove the spool (M) from the spool
housing (O).
M
O
L
N
M