Operating Guide

kobalttools.com

ASSEMBLY INSTRUCTIONS

5b. To install:

a. Align the battery with the cavity in the string trimmer housing.

b. Insert the battery into the handle until the battery release button locks into place.

c. Push down on the battery until it locks into place. You should hear a “click” once it is installed.

Note: The battery can only be installed one way.

WARNING: Follow these instructions in order to avoid injury and to reduce the rick of electric

shock or re:

• Replace the battery immediately if the battery case is damaged.

• Verify that the switch is in the OFF position before inserting or removing the battery.

• Verify that the battery is removed and the switch is in the OFF position before inspecting,

adjusting, or performing maintenance on any part of the string trimmer.

• Read, understand, and follow the instructions on Page 15.

5. Battery

5a. To remove:

a. Press the battery release button on the string

trimmer. This will cause the battery to raise out of

the tool slightly.

b. Grasp the trimmer rmly and pull the battery out

of the handle.

Note: The battery ts into the handle snugly in

order to prevent accidental dislodging.

IMPORTANT: The battery is not charged when it

is purchased. Before using the trimmer for

the rst time, place the battery in the battery charger

and charge. Make sure to read all safety precautions

and follow the instructions on Page 15.

Battery

release button