Use and Care Guide

NOTE: Always use tubing clamps to properly secure the air

tube. As there can be multiple surface areas in which the

tubing clamps can be connected, consult your local hardware

retailer for the proper fasteners needed for your specific

application.

7. For middle or drop down sections, the manufacturer suggests

the use of the in line shut off valve (D) (See Figure 9). Make

NOTE: Always use tubing clamps to properly secure the air

tube. As there can be multiple surface areas in which the

tubing clamps can be connected, consult your local hardware

retailer for the proper fasteners needed for your specific

application.

4. After connecting the air tubing to end of check valve, run your

air tubing away from your compressor to the area in which

you intend to run your air line.

Same direction

with air flow

kobalttools.com

OPERATING INSTRUCTIONS

6. At the top, use either a T connection fitting (E) or a 90 degree

angle (C) (See Figure 8).

CONNECTING TUBING FROM AIR COMPRESSOR:

NOTE:

PROPERLY CONNECTING T AND 90° CONNECTION

FITTINGS.

Always use tubing clamps to properly secure the air

tube. As there can be multiple surface areas in which the

tubing clamps can be connected, consult your local hardware

retailer for the proper fasteners needed for your specific

application.

5. Secure the air tube using tubing clamps. To secure: Press the

air tube into the tube clamp so that round bracket wraps

around the air tube. Secure the tube clamp using mounting

hardware (not included) and secure. The manufacturer

recommends tubing clamps be used every 4 ft. to keep

air tube straight (See Figure 7).

NOTE: Consult your local hardware retailer when selecting

fastener hardware (not included).

PROPERLY SECURING TUBING CLAMPS

Clip in

sure the arrow on the in line shut off valve is pointing in the

same direction that the air is flowing through the air tube. The

manufacturer recommends the in line shut off valve is easily

accessible to turn air flow off as needed.