Use and Care Guide

2. Prepare a 1/4 in. male plug (not included) by
applying sealant tape to the threading, wrapping
clockwise. Screw threaded male air plug by
hand into air inlet as shown in Fig. 2 and tighten
with a wrench (not included) for an airtight
connection. DO NOT OVERTIGHTEN.
NOTE: Sealant tape must be used on this
connection.
3. Select the correct impact socket (not included)
for the threaded fastener to be tightened or
loosened and mount it onto the anvil (B) until it
clicks into place as shown in Fig. 3.
4. If necessary for a longer reach, mount an
extension bar (not provided) onto the anvil until
it clicks into place, then mount the socket on the
adapter as shown in Fig. 4.
Use only adapters and sockets with a torque
rating equal to or greater than the tool itself.
Always make sure adapters and sockets are
properly mounted and secure before using
the tool. Loose attachments can break or fly
off, causing serious injury to the operator or
bystanders in the work area. Always follow
all manufacturers’ specifications for proper
attachment and use.